Electronics Forum | Wed Jul 16 05:16:49 EDT 2014 | spoiltforchoice
This number is going to vary hugely depending on the machine, how you operate and how many feeders you have. Smaller outfits might have a single operative whose job it is to setup, load, run & program the line. Regardless of how changeover focused t
Electronics Forum | Tue Apr 21 12:48:13 EDT 2009 | bk
ok you verified that the motor was bad. So now i would go back and verify that your voltages are still good on the back of the computer box and on the booster board. If they all check out fine. I would take the mot x board from your working machine a
Electronics Forum | Fri Mar 29 09:08:03 EST 2002 | caldon
Barcode!! The Siemens machines can have bar code Options added.On the Siemens Machines the bar code S/W is a little archaic. In theory You would have a bar code on a reel of part and a barcode on the feeder location (They are the black codes on the s
Electronics Forum | Fri Dec 21 00:06:55 EST 2007 | nhantruong
If you want to use fuji CP6 machine, you have to buy the the fuji flexa software.Because the old software from fuji (MCS or F4G) they are not support anymore. In the flexa software you can make top and bottom side in the same program, you can move th
Electronics Forum | Wed Jul 05 16:01:53 EDT 2006 | Chunks
I agree with Grant. The MYDATA machines we had were very easy to program, adjust and as Grant states make them pick up from just about anything. The best part of them was using partial reels or strips of parts. These machine don't care about havin
Electronics Forum | Thu Jun 29 23:39:25 EDT 2006 | grantp
Hi, Oh, never noticed this old comment, but now the threads been revived i can comment. I have actually owned three MYDATA machines over the duration of the last 6 years, and they all had accuracy problems. It depends on what your doing, but we got
Electronics Forum | Mon Mar 07 09:44:49 EST 2005 | anonomous
The machine sees a magazine, but with wrong number. somehow one (maybe more) wire from the magazine bus does not reach slot 3, as the other slots work, there is probably not a short, as the magazine bus work for other slots, the problem is probably i
Electronics Forum | Wed Jun 17 01:02:16 EDT 2015 | armandogomez
Hello Had a similar problem way back with the hydra, first go to the service program manually activate the hydra camera then move the Xwagon to place the hydra ref plate over the hydra camera and check first if the camera works, second the image you
Electronics Forum | Thu Apr 29 10:35:31 EDT 2004 | dougt
Start with a load cell (force sensor), you will need one that can handle the force range you will be placing. Someone please correct me on this if I'm wrong but I seem to recall that placement force runs in the range of a couple hundred grams. Chec
Electronics Forum | Thu Mar 04 17:32:23 EST 1999 | SMTASSY
| Mario: Interesting analysis. What does "Hand placement versus wrong component should only ave. 20-30 ppm." mean? Is that a subset of errors? Thanks. Dave F | What I mean Dave is that if you have a good (well actualy a great set-up) with all t