Electronics Forum | Mon Dec 15 22:05:02 EST 2003 | Sam
hi Liang, We had the same problem like you before, it happened during starts up the machine (S13) and run the production for the first or second board. We also replaced the 2/2-way microvalve of placement circuit. The problem had solved at the begini
Electronics Forum | Wed Dec 23 22:00:50 EST 1998 | Phillip Hunter
| Many machines now have adaptive pick that helps tune in the pickup as the 0402 part moves around in the pocket. Fuji may have a feature like this, but I think they adapt the pickup in only one axis (by adjusting the feeder rack). Unfortunately th
Electronics Forum | Thu May 12 00:18:55 EDT 2016 | darby
Sorry for delay - been flat out. Sr - I understand what you are saying. My concern is that combined with the head offsets and variations in pick points (i.e. having to teach feeder positions for very slight amounts like 0.05mm)then you cycle times wi
Electronics Forum | Tue Dec 13 11:33:57 EST 2016 | giulius58
Hy Guys, my old asymtek c740 have a problem ate the Y stepper motor, i want to try to repair it, but i need wiring diagram of machine.. where i can find them? Thanks and sorry for my english :)
Electronics Forum | Tue Mar 19 22:58:20 EDT 2013 | vikkaraja
Hello all, it has been a long time since I have visited this forum. I am in desperate need of some help. My cp7 is giving me an err 12200066 (The X- and Y- axis have been stopped due to a (HOLD) input. It stops runing after finish running every boar
Electronics Forum | Sat Aug 19 21:06:09 EDT 2006 | mika
Hi all, At our Fuji CP-6 machines we place a lot of 0402:s, 0603:s and 0805:s chip capacitors. Our problem is that the height of the components can sometime be very extreme from different vendors. I am sure you all have experience of this phenomenon
Electronics Forum | Mon Sep 10 17:52:30 EDT 2001 | mparker
Are you doing actual measurements of the dummy parts placements? or are you just doing a visual go/no go check? If doing actual measurements, be sure to use mil inch units of measure rather than mm. Mil will give you more accurate readings. mm force
Electronics Forum | Thu Mar 22 09:49:16 EDT 2007 | Manyhatz
You shouldn't have any problem with the SM320 doing what you're asking above. In fact I think it will do it quite better. We have a two machine TP-11 Hydra line and a two machine SM320 line and I can tell you one SM320 can get the job done better.
Electronics Forum | Fri Dec 21 09:40:40 EST 2018 | kdexter0928
I am at wits end with this machine. The MTU on my IP2 will not zero set. It gives me a few different errors depending on its mood. I receive MTU T- OT, MTU X- OT, or MTU Y- OT. when the machine attempts to zero set it travels until it OTs. I have tri
Electronics Forum | Fri Jan 12 11:04:09 EST 2007 | mika
zero > in manual Control > bring the head close to the end of the machine so that you can reach the head => Diagnostic meny > engage the clutches and THIS IS VERY IMPORTANT: use Extreme Caution (you can flip off the X-Y circuit braker on the lower ba
.gif)
