Electronics Forum | Wed Oct 13 11:41:27 EDT 2004 | raj_nz
yamaha yv100gx
Electronics Forum | Fri Feb 02 11:24:13 EST 2007 | vze3nk2r
is there a level above 100,000 that does not require the use of booties for general assembly work?
Electronics Forum | Fri Apr 20 07:30:14 EDT 2001 | wbu
In short: the measured deviation / the length this deviation occurs * 100% = % of deviation Actually we encounter mostly "twist" so we put the board on a flat surface, hold it down at the corners to see if any of the corners lifts, measure the heig
Electronics Forum | Mon Apr 23 11:44:55 EDT 2001 | CAL
650 Standards are also located in the back of IPC JSTD-001. I am currently looking at 4 pages on bow and twist. Percent bow = R1-R2/L x 100 (R1= Highest point; R2=lowest or resting point; l= length) Percent twist=(R1-R2)/(2xL)x 100 Sorry if this is
Electronics Forum | Mon Dec 22 15:33:42 EST 2008 | robinj
http://www.3ktehdas.com/uutiset/Next_05.pdf I hope this link helps.
Electronics Forum | Mon Dec 22 14:15:41 EST 2008 | ck_the_flip
As Emil says, it's 100% the glue! Your paste is not designed to hold parts on at wave solder. Reflow is MUCH hotter than glue, so I doubt you're not adequately heat-curing it. Possibly, the glue cure is "too hot" and maybe making the material brit
Electronics Forum | Sat Nov 03 11:08:24 EDT 2012 | anvil1021
We have experience with this alloy, but with enig and we did start with PB HASL, none of our PCBs would of course pass thermal cycling at normal temperatures with the HASL so we went to ENIG. we could thermal cycle at 100-115C with no issues. We foun
Electronics Forum | Wed Aug 10 02:38:36 EDT 2016 | zxcvb
I guess I've been somewhat ignorant when it comes to the finer details of pcb layout. Lately I've read a couple of books that try their best to lead me on the straight and narrow. Here is a couple of examples of a recent board of mine, and I have hig
Electronics Forum | Tue Mar 06 06:58:29 EST 2018 | griinder
Thank you guys for your help and detailed explanations. I have successfully been able to teach pads as fids. The camera view is very annoying, but manageable. Especially when teaching inspection positions. On the momentum's we can use Gerber EZ Teac
Electronics Forum | Thu Apr 26 12:06:08 EDT 2007 | basem
$100K for this entire line. We are thinking of getting a Chinese made reflow oven that looks pretty good at $25K. Also, we need to deposit solder using a dispenser as stencil printing will be reserved only for higher volume boards. It will not be pra