Electronics Forum | Thu Sep 21 14:29:58 EDT 2006 | realchunks
Gotcha, I used to be in charge of a pneumatic gun that clipped and bent the leads. Hand held units that worked rather well. The operators where very good at aiming the clipped lead too! Anyway, you may want to visit Panasonic, they have/had a disp
Electronics Forum | Mon Mar 05 14:44:51 EST 2007 | daxman
Hey, I've seen a lot of AP25's with snuggers. I don't know if they all came with the pneumatics or not..but if you have the snugger reg. guage, just underneath the Z table, you should be okay. The fellas at goppm (www.goppm.com) have a lot of knowl
Electronics Forum | Tue May 22 10:05:10 EDT 2007 | aj
Hi All, I acquired an AMP Semi-Automatic Press for backplane connectors and the like a while back , unfortunately without the Manual. Its part # is G776272. ( pneumatic). Does anyone out there know where I can get one ? I will try and contact th
Electronics Forum | Fri Jan 11 00:32:16 EST 2008 | johnlee9210
Prior to packing the boards, we cover the marking on the IC by dispensing epoxy on top it. This is a way to protect our design so no one can copy it. We have a lot of boards and the optr takes a long time doing it manually. im thinking of using a pne
Electronics Forum | Mon Feb 11 13:41:12 EST 2008 | sliebl
We use EFD pneumatic dispensers. Several are second hand from our favorite online auction site. I just checked on there and there are 3 units currently less than $50. Have the bean counters where you work get you one. Tell them your hand hurts from u
Electronics Forum | Tue Oct 27 22:46:21 EDT 2009 | fulldrawmike
if your feeder is indexed via an air/pneumatic cylinder like say a bimba? put a couple of drops inside the cylinder via one of the fittings, index it a few times and see if it does not pick the pace up some. don't oil the index shaft, could cause t
Electronics Forum | Fri May 20 09:13:58 EDT 2011 | ck_the_flip
We have issues with the Philipps Luxeon Rebel LED where the part sticks to the cover tape during advancement. This causes the part to get flopped around in the pocket or the component gets dropped and damaged when the feeder advances. Has anyone ex
Electronics Forum | Mon Feb 11 11:28:43 EST 2013 | marcelorotofrance
yes, Bob, I agree about that. But I can't afford them by now. But the problem is that I had to reject almost the 50% of the feeders that came with the machine, because are useless even for 1206. I also work with a very old but faithfull Juki, with it
Electronics Forum | Tue Nov 17 14:48:41 EST 2015 | jpal
I have to figure out how to install a two-pin JST through-hole connector. It is a press-in style. We have pressed in larger connectors on single-sided boards with our pneumatic machine but this is a small connector on a double-sided board with small
Electronics Forum | Wed Mar 30 11:59:56 EDT 2016 | cbeneat
Our company has 8 EKRA X5-X5 Pro's we do not use that function on any. Personal preference I guess. I assume the cartridges are set up like the pneumatic gun type dispensers, drop in a cartridge and go. Not in Europe, sorry no knowledge of where t