Electronics Forum | Wed Apr 29 04:57:08 EDT 2009 | davepick
It depends on the application what will be considered the biggest issue to avoid (production or longterm reliability). Tin Whiskers are bit of an unknown quantity - but a more realistic problem could be dendritic growth / electromigration forming sho
Electronics Forum | Fri Mar 26 15:48:31 EDT 2021 | grahamcooper22
Leaded HASL on small pads can be quite difficult to print on...the HASL tends to be domed rather than flat..and that can affect print quality...you really need a perfectly flat pcb pad to print paste on when you are assembling 0.5mm QFPs. If the pcb
Electronics Forum | Thu Mar 10 15:43:06 EST 2005 | steve
Thank you both for your assistance. I knew that I could count on you folks. The customer has purchased No-Clean flux and is using it as we speak. Hows that for customer service.... All in a days work... Thanks again You make me look good!!! Steve
Electronics Forum | Mon Nov 14 10:10:52 EST 2005 | davef
When soldering your full tin (no lead) and Pb95/Sn5 solder components, you need to modify your PbSn reflow recipe to compensate for the higher melting point of the changed solder alloy [with your Sn62/Pb36/Ag2 solder paste] on those component leads.
Electronics Forum | Tue Feb 16 21:29:18 EST 2010 | actioncontrols
I predict you will have no problems with your soldering. Remember that all plating is only a few microns thick and quickly washed away by the molten solder. We have used white tin, immersion gold, OSG, etc. for quite a while with leaded solder and
Electronics Forum | Thu Sep 03 22:03:32 EDT 2020 | SMTA-64386139
Both conditions are acceptable for this bottom brazed flat pack package. The solder coverage must be within 0.070 inch of the lead/package interface per MIL-PRF-38535, paragraph A3.5.6.3.4.a. While that requirement could allow for a gold gap near t
Electronics Forum | Wed Aug 15 16:04:23 EDT 2001 | davef
First, responding to your question � Several things on copper dissolution in solder are: * A 50um copper wire will dissolve in 60Sn / 40Pb solder at: - 200�C solder in 55 seconds; - 250�C solder in 20 seconds; - 300�C solder in 5 seconds; - 350�C so
Electronics Forum | Wed Jun 02 05:40:35 EDT 2004 | johnwnz
Is there not an issue with reflowign the SAC ball's in term's of drivign up the lead contect in a lead free joint that increases the risk of failure in them? certainly dramatically increases voiding... have some pictures of soem that a customer tried
Electronics Forum | Thu Nov 10 08:23:35 EST 2005 | arclightzero
Hello, I am currently trying to isolate internal fallout problems with very low yield substrates mixed with great yields and have recently found that we are using a Sn62/Pb36/Ag2 solder paste with full tin (no lead) components as well as Pb95/Sn5 sol
Electronics Forum | Mon Apr 03 02:09:58 EDT 2017 | soldertraining
Restriction of Hazardous Substances (RoHS) bans products that contain a high level of hazardous materials from entering the market like the EU market. If we talk about PCB products - The printed circuit board services – including both conventional an
.gif)
