Electronics Forum | Wed Sep 29 11:42:24 EDT 2021 | stephendo
"A shunt is an electrical device that creates a low-resistance route for a current to flow through. This allows the current to flow to a different part of the circuit." From that page. It sounds like you are using the resistor in a current limiting
Electronics Forum | Tue Feb 28 20:56:12 EST 2006 | davef
Here you go ... PCB FR-4 Inspection Manual 1 Introduction This defines the minimum acceptability requirements. It is not intended for use as a performance specification for the Company or procurement. It is based on the requirements of Acceptabi
Electronics Forum | Fri May 26 04:58:19 EDT 2023 | auriga2001
I agree with the two other replies. Left alone, it is a defect. If it's just excess adhesive or coating, you can use IPC-7711/7721 'Rework, Modification and Repair of Electronic Assemblies' for guidance on removing. Section 2.3.1 explains how to te
Electronics Forum | Thu Feb 17 22:30:09 EST 2000 | Dave F
Alberto: There's no rules, but it works sorta like this: RESISTORS Usually marked in ohms using a standard code: First two numbers is the value Third number is the multiplier 102 = 1.0 x 10� ohm = 1000 ohm = 1 kW CAPACITOR Usually not marked. When
Electronics Forum | Thu Feb 17 22:30:09 EST 2000 | Dave F
Alberto: There's no rules, but it works sorta like this: RESISTORS Usually marked in ohms using a standard code: First two numbers is the value Third number is the multiplier 102 = 1.0 x 10� ohm = 1000 ohm = 1 kW CAPACITOR Usually not marked. When
Electronics Forum | Mon Aug 30 16:10:10 EDT 1999 | Dave F
| I have looked through the IPC web page and surfed to frustration. Can somebody give me a lead? | Brian: We don't use an etched board. We use a special stencil, described below and print on bare copper laminate. 3 Solder Wetting Test. Recogniz
Electronics Forum | Tue Jan 05 18:07:53 EST 1999 | Dave F
| I am looking for information regarding post wave soldering of stranded wires into a circuit board using OA core wire solder. We do a final pass thru the cleaner after the hand soldering but I'm concerned about any OA flux residue that may have wic
Electronics Forum | Tue Nov 11 17:35:08 EST 2008 | davef
SM-840, is a material qualification document only, with all the test requirements applicable only to a defined test coupon, not to production boards. So, it's useless for what you're trying to accomplish. As assemblers use A-610 - Acceptability Of E
Electronics Forum | Tue Jan 30 13:53:50 EST 2001 | cebukid
Wolfgang is correct - Dwell Time is influenced by conveyor speed and of course, pump speed. Contact Length (the length of contact between board and wave) is something that you might want to track. Contact Length greatly influences process defects l
Electronics Forum | Thu Nov 11 14:13:57 EST 1999 | Dave F
Thomas: From what you're telling us, you seem to be thinking correctly: 1 Paste should not spread appreciably in preheat 2 Something has changed, because you've not had this problem, until recently Two things to consider: 1 Has any thing changed