Electronics Forum | Mon Jun 26 08:57:17 EDT 2017 | capse
If N2 is not an option, the cut wire feeder or drilled wire are your best bet for now. You need to optimize wire feed rate as well. The solder joint on the robot takes about the same time to form as in manual soldering. If you need to speed the solde
Electronics Forum | Thu Jul 06 03:43:22 EDT 2017 | jamesbarnhart
Electronic devices required higher speed, I/O capability, and density to meet standard requirements. Automated robotic soldering solutions that meet the demands of applications are too challenging for hand soldering. Manual soldering, even with the m
Electronics Forum | Thu Jun 01 07:40:23 EDT 2006 | netellink
I have a Suzuki vision machine with 4 heads (SMT-1000VL). This machine is using the camera to inspect the nozzels (4 sets) in the nozzel tray changer every time it is going to change the nozzel(s) in the 4 heads. The problem I have is now the machine
Electronics Forum | Mon Aug 24 07:32:34 EDT 2009 | hurr
Hi Joane, this flux is primarily designed for wave soldering. I think that manual soldering it´s possible. Certainly it´s very hard to dispensing correct amount of the flux. Succinic acid is one from all ingredients of this flux. If you have this
Electronics Forum | Sun Feb 13 18:47:21 EST 2011 | gabriel1blue
Thank you for your fast reply, head 1 moves to the pick up location and stays up, then it moves to the dump location and moves down to drop the part, it was running before just the offsets where off (moving up and down). If I chance the head from hea
Electronics Forum | Thu May 21 18:11:37 EDT 2020 | gabriel1blue
Thank you for your reply. I tried to contact Panasonic support but even them have a hard time getting information on this machines. I have been waiting for them to let me know if they help us but no luck yet. I did replaced the a few backup batteries
Electronics Forum | Thu May 25 18:58:49 EDT 2000 | Mukesh Lad
We are a tape and reel house,we use a variety of machines. If you are looking for low voulume, low cost and easy set up for you operators. I would look at Systemation MT-30, this is a good work-horse, I have used them for 10years for small runs, no
Electronics Forum | Fri Aug 27 10:25:52 EDT 1999 | Matthew Park
Is it feasible to have one type of board carriers to take boards thru 1) glue curing process for first side and 2)invert carriers with boards, and 3)reflowing second side, and 4) do manual stuffing of th components and 5) take them thru selective wav
Electronics Forum | Sat Feb 12 13:19:27 EST 2011 | tpappano
A simple trick I read either here or on another P&P forum is to use "Silly Putty". Place a small thin spot of Silly Putty on the top of the front conveyor rail, and put the machine in "manual" mode. Steer head #1 over the putty and lower it, leavin
Electronics Forum | Wed Dec 09 05:01:33 EST 2015 | luki
Hello, I am a new user of the machine CSM84VZ III and learn to program. After formatting a disc machine lost all settings(I did not know that the settings are on the disc), most of which I have already set. Now I have a problem such that when I try t
