Electronics Forum | Sat Jul 21 08:45:10 EDT 2001 | davef
In the past, we have spoken [typed?] about controlling the temperature and humidity of our plants. And it's probably good to do that from solder process control, ESD danger reduction, and human factors stand-points. We are looking to lower our ener
Electronics Forum | Fri Oct 28 12:09:31 EDT 2005 | Cmiller
Your vibe feeders will probably work fine. Using the old tape feeders on a Lighning head will limit the speed of the machine big time. I have not done it but I dont think its a good idea. We considered buying used feeders to offset the cost of our ne
Electronics Forum | Thu Jan 12 15:50:50 EST 2006 | Cmiller
I would agree with JAX for a general estimate. If you have a few specific boards Universal can put them in a simulator and give you pretty close estimates. I would reccomend you go to thier NY facility and actually run some boards and get to know the
Electronics Forum | Thu Mar 02 05:07:51 EST 2006 | pavel
We have bought an old zevatech 730 in Bosch auction (hello MikeZIG). There seems to be something wrong with the X axis servo, the machine is vibrating when the head is moving fast (in fact the machine is dancing, in the race with washing machine it w
Electronics Forum | Tue Nov 18 13:10:16 EST 2008 | andersenequipmentllc
I need a service manual for a Philips CSM84 type > PA1306/20. I have the PA1306/40 manual, if that > is any use to anyone. The 1306/20 was the last > model with analog servo amps and DC brush motors, > the 1306/40 was the first with AC brushless
Electronics Forum | Thu May 02 15:29:19 EDT 2013 | jim_n_hky
I can't answer your specific question on the floor, but I have some suggestions. The equipment manufacturer should be able to provide the floor loading requirements. A structural engineer should be able to translate that into specs for hte constructi
Electronics Forum | Sun Nov 27 16:53:39 EST 2016 | ttheis
Our UP500 has been running great for a few months then the AC/DC 5/12/24V power supply stopped working and the PC could not communicate with the cage. The PC screen also got very noisy. We replaced the power supply with a used replacement and the ma
Electronics Forum | Wed Jul 04 15:13:17 EDT 2001 | davef
Dunno, but our a/c cats asked us the same question a cuppla of years ago and we couldn't figure-out what they were talking about. So to not get wrapped around the axial, we defined our heat sources in terms of time, temperature, durations, etc. Thr
Electronics Forum | Thu Oct 28 20:14:28 EDT 1999 | xujun
hi,sai: we have a same m/c that is cp-43,but we haven't encounter the problem about servo board.I think is ac- speed- adjustment servo board.if you can conform th board is bad,consulting the fuji service agent is the best way! best regards
Electronics Forum | Sat Jun 13 01:02:54 EDT 1998 | Scott McKee
| Is their an IPC standard for the water that is being used in the water wash. I have been looking and at this time have not found any thing. Try these: IPC-AC-62 Post Solder Aqueous Cleaning Handbook