Electronics Forum | Thu May 30 10:31:03 EDT 2002 | robbied
Hi Yannick. This is an issue that we are just recently getting into but here is some ifo that I have gathered so far. I have seen/ used 2 different rework machines. The one we have bought is a 'PACE TF2000' which was at the lower cost end of the mar
Electronics Forum | Tue Mar 30 06:27:22 EDT 2010 | ristikas
It happens on the middle of the stecil cleaning. The camera and the cleaner will stay under stencil in half way back. Then machine asking the initate the motors. If to press initate then the pcb stopper will hit the rails. Usually we move camera and
Electronics Forum | Tue May 23 12:18:25 EDT 2000 | mike weekes
Which companies would you consider for protective coatings, (conformal coating) and other levels of protection? I am taking a fresh look at alternatives. Know any good tests for testing compatability of coating with flux - aqueous or no clean? SMT
Electronics Forum | Wed Mar 01 16:58:03 EST 2000 | Dave F
Robert: On your balls: Solder suppliers make several "standard balls" and can advise you. On your cleaner: Recycling water / direct to drain? Most batch cleaner suppliers can advise you on recycling and filtering systems to keep you out of troub
Electronics Forum | Wed Mar 01 16:58:03 EST 2000 | Dave F
Robert: On your balls: Solder suppliers make several "standard balls" and can advise you. On your cleaner: Recycling water / direct to drain? Most batch cleaner suppliers can advise you on recycling and filtering systems to keep you out of troub
Electronics Forum | Wed Aug 14 10:44:04 EDT 2013 | sarason
In my limited experience. A Domestic Dishwasher with no water recycling like which is offered on some of the newer high priced models works a treat. Clearly this is batch. Inline filtering of the water supply is a good ideal. There are several ways o
Electronics Forum | Wed May 29 15:08:03 EDT 2013 | artposada
we recently installed an aqueous cleaner. it is consuming alot of energy and di resin beds. is it advisable disconnect the resin bed and go straight to city water? the cleaner has its own filter system.
Electronics Forum | Thu Dec 03 15:41:09 EST 2015 | proceng1
We do run them through an Aqueous washer, but I don't see excessive deposits or anything before washing. And our wash is just heated DI water.
Electronics Forum | Mon Oct 03 12:11:18 EDT 2005 | PWH
Soon we will be manufacturing board assemblies on our SMT lines that will utilize both lead and lead free water soluable solder pastes. I have read some discussion about change-over from lead to lead-free jobs related to machine cleanliness, etc. H
Electronics Forum | Tue Aug 30 15:05:23 EDT 2005 | Shean Dalton
Dear Ing, Have you analyzed why some RF device aren't operational after washing? An assumption is that failures are related to the ultrasonic energy applied. Other possibilities are for poor rinsing, poor drying, inadequate washing on those failed