Electronics Forum | Thu Oct 03 18:00:51 EDT 2019 | ddfreeze
Got a used mpm up2000. It gives z axis hardware limit warning when trying to teach vision. The board raises to camera then drops back down. However when loading a board for tooling, the board stays raised up. The z table can be manually raised up n d
Electronics Forum | Tue Jan 17 11:51:14 EST 2023 | eurolan
Hello, I have several manuals in English, but not the service manual. If it is a PDF where I could eventually use Google translate would be great to have. Actually, our friends from China sent us some videos on this, but it is not understandable -
Electronics Forum | Sat Jul 08 02:10:31 EDT 2023 | unsung
Wipe down and clean the 2 Gold strips on Y Axis and the encoder ( located on both sides of the machines covers must be removed ) Probably has dirt happen to someone who had an old universal 2007 that was sitting outside in the open air for a few day
Electronics Forum | Sun Aug 18 21:06:45 EDT 2019 | dman97
Based on the fuji error codes, It says that the ARCNET cable is disconnected. Make sure that all cables from this module are connected to the QP.
Electronics Forum | Fri Oct 04 13:47:25 EDT 2019 | compit
I had as I placed the supports at the back - when lifting Z touched the rear rail - check.
Electronics Forum | Tue Jan 17 10:49:16 EST 2023 | dbrenkus
I have Korean CP45 service manual if you are interested.
Electronics Forum | Tue Jan 17 11:48:38 EST 2023 | eurolan
Hi, Thanks for your reply. This machine actually doesnt have such a button. It can home itself, but it tries to through the whole process, and stops when trying to find Z6 zero point.
Electronics Forum | Thu Jan 19 08:11:27 EST 2023 | eurolan
Hello, Do you have information about the part number (if any) and/or where we could buy one? Thanks!
Electronics Forum | Fri Jul 07 12:42:42 EDT 2023 | ttheis
We checked the three pacsci pc800 servo controllers and they all look OK, no red or error lights. VRM amps all look OK. Still haven't found the issue.
Electronics Forum | Sat Jul 08 02:21:40 EDT 2023 | unsung
I did clean the gold strip and black encoder box pretty good it took me a few trys but it work ( it did had rust on the machine from the rain I guess... from being out side for awhile)