Electronics Forum | Tue Sep 25 14:08:59 EDT 2001 | davef
Oooo, the solder on the pad and PGA ball is flowing during reflow down the via to the secondary side? Why didn�t you say so?? ;-) Why would you expect that gravity and capillary action wouldn�t force solder to flow down the solder plated via to the
Electronics Forum | Thu Jun 19 21:39:31 EDT 2008 | mika
Hi, we used to have a RoHS package with uBGA 380 Solder ball's 0.8 mm pitch approx 15x15 mm, bump size is 0.4mm on a 0.33mm pad. Suddenly we need to use another vendor for various reasons. However, the new bump size is 0.45mm according to specs and t
Electronics Forum | Wed Sep 08 15:59:25 EDT 2004 | kbayram
Hello, I'm looking for a lower end used machine that can place a 55x44mm sized bga component, placement speed is n't concern. At the moment I have only found the quad ivc to be capable although I'm worried about the placement accuracy and repeatabi
Electronics Forum | Thu Aug 17 09:57:16 EDT 2006 | jwn
Hi all, I need to find a solution for a problem I have. I need to replace BGAs which have been glued to a laptop board with superglue (Loctite). How can it be done without removing the pads when trying to remove the foreign glue? thanks in advance
Electronics Forum | Tue Nov 08 05:00:23 EST 2005 | rlackey
Hi CW, Regarding orientation, yes, your diagram is right - see the following link for confirmation. http://search.murata.co.jp/Ceramy/image/img/A18X/C2EB3C.PDF Regarding information on bending strength you want to talk to your local Murata office
Electronics Forum | Wed May 12 15:22:24 EDT 1999 | WDR
Earl you posted a message on 1-14-99 about converting to VOC free flux. Have you completed your evaluation? Could I get a copy of any data supporting your conversion to VOC free? Thanks WDR
Electronics Forum | Mon Jun 07 21:31:46 EDT 2004 | davef
That's thin board. The test that you ran is the best method for determining the specific answer. Bob Willis says, "Use pad mating to lead wetting area. Some have found the ratio to be as much as 44 grams/sq in." Bob Willis and Phil Zarrow have po
Electronics Forum | Tue Jun 06 11:57:12 EDT 2006 | Chunks
IPC 610 says acceptable Class 1 (Class 2, 3 indicator) if they are entrapped/encpsulated balls within 0.13mm of lands or pads. or exceed 0.13mm in diameter. Defect Class 1,2,3: Solder ball violates min electrical clearance. Solder balls not entrap
Electronics Forum | Wed May 12 20:32:14 EDT 1999 | Earl Moon
| Earl | | you posted a message on 1-14-99 about converting to VOC free flux. Have you completed your evaluation? Could I get a copy of any data supporting your conversion to VOC free? | | Thanks | | WDR | | WDR, We are awaiting the latest dat
Electronics Forum | Wed Mar 14 13:16:54 EDT 2007 | Shane
I have a customer that designed a fine pitch BGA into a board, and has put small vias in the middle of each pad on the PCB. Anyone have any ideas on how I can prevent the solder from the BGA from flowing through the vias and causing voids or no cont
.gif)
