Electronics Forum | Sun Dec 28 05:31:59 EST 1997 | Bob Willis
We have a x ray inspection criteria video and poster set which may be of interest check out our home page www.bobwillis.co.uk | | I'd like someone gives me a tip for elemating of voids | | in the mico BGA solder joint and the method of inspection |
Electronics Forum | Thu Mar 22 13:48:23 EDT 2007 | Gary
Sorry. I ment to send you to http://www.smttools.com/ Look at the BGA-100 scope.
Electronics Forum | Mon Nov 12 06:05:15 EST 2001 | nop_e
Dear all I 'm looking the minimum X-Ray machine capability that is capable to inspect the solder joint of BGAs, Fine pitch BGA and CSP such as open, poor solder joint ,etc... What is the machine specification needed? Thank you for your advise.
Electronics Forum | Fri Jan 15 15:29:03 EST 1999 | Jason Hall
| Our spec on voids is 30% ball diameter in the center. On the component to ball and pad to ball interface, we use 25%. To determine this spec, we asked around. I don't know of any studies that have been done to verify if this is OK | | Regards | Ji
Electronics Forum | Thu Dec 09 07:46:42 EST 2004 | davef
We did this for BGA pads, but have not thought about other types. So, this may or may not apply for those. Pad defined by:||Advantages||Disadvantages Non-solder mask||No point-of-stress concentration at edge mask and solder ball||Smaller pads have
Electronics Forum | Tue Sep 14 14:52:22 EDT 2004 | Carol
During processing, the solder in the vias reflows and forms solder balls. PCBs have solder in random PBGA vias from the board manufacturer.The manufacturer says this is a result of the HASL process and is unavoidable. We use HASL finish, multilayer,
Electronics Forum | Thu Mar 16 16:23:12 EDT 2017 | u4bga
I'm wondering what can we learn from an X-Ray analysis of solder joints - specifically, non-BGA joints (through-hole & SMT) joints.
Electronics Forum | Sat Sep 18 08:26:10 EDT 2004 | davef
Carol: If you would have problems both covering the via and keeping mask from the BGA pads, maybe you via are too close to the pads. Maybe some of the IPC pad design guidelines would help.
Electronics Forum | Fri Dec 10 08:42:37 EST 2004 | mattkehoe
We had some bad experiences trying to work with soldermask defined BGA pads. If the opening in the soldermask is right to the edge of the copper/pad without a space it can leave reside on the pad and nothing will stick to it. See http://www.sipad.com
Electronics Forum | Fri Jan 15 09:27:18 EST 1999 | Earl Moon
| I saw the problem of void in solder bump or in lead less component or some BGA. But I didn't have standard specification of that void is accept or reject? Do any body have the better idea or suggestion of the criteria ? | | Thank you, | Wirat
