Used SMT Equipment | Soldering - Reflow
Vitronics XPM3i Reflow oven 10 zones 2 Cooling Zones December 2010 Manufactura Date Nitrogen edge rail mesh belt left to right flow direction
Used SMT Equipment | Soldering - Reflow
• Nitrogen • Edge Belt Conveyor • Mesh Belt Conveyor • Auto Chain Oiler • 350 C Max Temp • Flux Management System • 480, Volt, (3) Phase • (10) Upper and (10) Lower Convection Heating Zones • (2) Cooling Zones • Condition: Complete & Operat
Used SMT Equipment | Soldering - Reflow
• Edge/Mesh • Air • 5 zones Condition: Complete and Operational, “ As is Where is” Location/Shipping: North America/EXW Availability: Immediate
Used SMT Equipment | Soldering - Reflow
Details: • Edge Rail with Mesh Conveyor • Power Requirement 480 Volt Condition: Complete and Operational “As is Where is” Location: USA (all shipping costs are the responsibility of the buyer) Available: Immediate for Purchase
Used SMT Equipment | Soldering - Reflow
Details: • 9 Heating zones • 2 Cooling zones • Air • Mesh belt • 208/240V -3 Phase – 50/60Hz Condition: “As is, Where Is Shipping: USA / FOB Origin Availability: Immediate for purchase
Used SMT Equipment | Soldering - Reflow
Vitronics XPM2 reflow oven SW Rev 12.10 Configured: • Edge/ Mesh • Air Condition: Complete and Operational. Available for inspection prior to shipment Availability: Immediate for purchase. Lead time for shipment 3-6 weeks Location/Shipping:
Used SMT Equipment | Soldering - Reflow
Gen5 Waterless Cooling and Flux Separation System – Heated Cooling Module in 1st Cooling Zone for Controlling Cooling Slope – Enhanced Waterless Cooling Modules for Low Product Exit Temperature. Complete Computer Control System including: Flat Panel
Used SMT Equipment | Soldering - Reflow
The 1800 reflow oven models support high mix / high volume throughput… at speeds up to 32 inches (80 centimeters) per minute, while conserving valuable factory floor space. Rapid response times and precise temperature controls assure process uniformi
Used SMT Equipment | Soldering - Reflow
Vintage: 2006 Details: • 7 zone, 1 cooling zone • Rail & Mesh • No center rail support • Auto chain oiler (not enabled) • Controller: Intellimax 2 • Software rev: Wiscon 6.0 • Has air cooling
Used SMT Equipment | Soldering - Reflow
Vintage: 2006 Details: • Edge rail & Mesh belt • Air • 480v – 50/60 Hz- 3 Phase •&n