Electronics Forum | Wed Oct 26 21:44:42 EDT 2005 | KEN
If your sure your drive lines are staying put then it must be the motor. ... odd no servo feedback alarms though. That's why I thought problem might be mechanical. Does the yv84 use servo's? IF yes, then no brushes to wrory about. Don't bother t
Electronics Forum | Tue Aug 10 20:34:44 EDT 2021 | jamesatqkits
Hi Could you explain what the IF board is? I am getting a 1002 ALARM occurred in MIR axis, i cannot figure out what its trying to tell me. I have never been able to make this machine work. Would you have any ideas? Thank you have a great day. I was r
Electronics Forum | Sat Jan 26 15:47:10 EST 2019 | dfl
I'm with an annoying problem with an IV-c. Almost all the time the Y-axis "stuck" when the machine is homing. The motor tries to move the axis but only make a sound. If I move the axis by hand it can complete the homing and then goes to the IDLE. So
Electronics Forum | Thu Sep 16 18:43:57 EDT 2010 | slwolbert
Hello Daxman, Thanks for the input. Yes, the CP2 is closely related to the CP4 and does have the analog servo amps as you deduced. I did a wiggle test on the connectors and found that the x-y-r servo amp alarmed right away and blinked the x axis a
Electronics Forum | Thu Aug 29 14:20:17 EDT 2013 | nophsem
Thanks for the response bobpan! LED's on the driver cards work well (green with doors closed and both red&green on with door open), and I don't use the carts. The head doesn't move after power on and inmediately you can listen alarm.
Electronics Forum | Thu Mar 21 12:09:28 EDT 2019 | alexcouto
Hello Bukas, thanks again. Since at an early stage I switched heads # 1 and # 6 and they are not compatible, then I went through the manual and figured out why. in order to start at the beginning and check that it had not damaged anything, I put the
Electronics Forum | Sun Jan 27 17:59:25 EST 2019 | bobpan
The y-axis on that machine is left to right. If this is the axis you are having a problem with....check the motor. I have had to tighten the tension on it before. If you notice you lose steps after running for a while then this is going to be the iss
Electronics Forum | Fri Oct 02 11:59:37 EDT 1998 | jon Medernach
| I am experiencing solder paste comtaminatin of nozzels on 0603 size components resulting in missing components. The machine is failing to alarm under these circumstances. Has anybody else experienced this problem & found a solution? | Just a sugge
Electronics Forum | Fri Oct 07 04:26:13 EDT 2022 | acouto
We are having an issue after performing a head cleaning. Error 0x0000D005 - "An error that can be cleared (alarm) has occurred at the axis" We are trying to solve this problem but every time we insert a head into the cleaning machine, it gives us the
Electronics Forum | Tue Feb 11 00:21:54 EST 2014 | bren
I suddenly encountered this error F-AXIS-C/9 Error says Axis has unstable zero point. Any advise?
