Electronics Forum | Thu Jan 23 15:57:58 EST 2014 | bestglobalsmt
Hello! > > Go on the Service Button (bottom right) > password could be 2211 or 9060. In that menu you > should be able to change direction. > > Please > tell me if it works! > > Bye > > Christian christian - do you have any idea where the op
Electronics Forum | Thu Nov 08 02:09:05 EST 2018 | vinitverma
If the nozzle gets changed properly but the machine still gives the sensor, then the FNC nozzle detection sensor needs to be adjusted. It is a set of 2 sensors on a plate on the either side of the FNC. If the nozzle is not changed successfully and ge
Electronics Forum | Mon Mar 19 16:50:23 EDT 2018 | magergar
Acording to the manual the resolution for the narrow camera is 22.5 um/pix but is setup at 45um/pix (wide resolution), I tried to change it in the proper 113.Camera1_Pixel_X and 114.Camera1_Pixel_Y but I'm not allow to change this parameter it is bl
Electronics Forum | Wed Nov 20 09:23:53 EST 2019 | alpha1
We had a board we fought with for a while with solder balls. Checked everything, Stencil thickness at .004, reduced apertures, changed paste 3 times, changed profile 3 times. Finally changed board vendors. Went from HASL to Emersion Gold. Problem sol
Electronics Forum | Fri Jan 10 13:21:34 EST 2020 | emeto
Yes, think of 3prints/minute 24 hours. This is about 4000 prints a day. than you have a marginal process, because customer locked design and doesn't want to change anything. So in our case for 70k-100k prints and we had to change them as the perform
Electronics Forum | Thu Jun 24 08:05:21 EDT 2021 | vinitverma
That's the correct way when optimizing a new program or with less part numbers. But when reoptimizing a running program, it may not be so convenient to change all feeder numbers to '0'. Here is where changing the position to 'Relative' helps without
Electronics Forum | Fri Jan 06 09:39:35 EST 2023 | micropak
In newer machines, after changing a motor you have to do an "Axis Home Calibration". Once I changed Z-Axis belt on an SM-482 and it refused to successfully do "Axis Home Calibration. Then the solution was to remove the belt, rotate the motor pulley a
Electronics Forum | Thu Aug 24 17:08:58 EDT 2000 | Dr. Ning-Cheng Lee
Depending on the stress condition experienced by the solder joints. For joints under a greater stress, the time to reach equilibrium can be shorter. Of course, the change is also more significant in phase structure. For low stress conditions, it may
Electronics Forum | Wed Apr 03 05:47:31 EST 2002 | ianchan
Hi Guys, We have a customer who is requesting us to issue a document ECN (engineering change notification) record to them, IF we have any changes in : 1) direct materials used, 2) indirect materials used, 3) machine configuration, 4) change in SMT L
Electronics Forum | Mon Sep 09 08:21:37 EDT 2002 | mk
What kind of changes could be expected by changing from a HASL finish to gold? We have a board the had been being coated with HASL but was changed to gold to make priting easier. Now, even though the soldering looks fine, we are getting fallouts at G
.gif)
