Electronics Forum | Tue Mar 07 07:56:54 EST 2006 | amol_kane
Hi, I have a PVA conformal coating machine. Does anyone out there have a method to control the process once it is in the automated mode? my problem is that eventually the coating gets into the keep out areas a little bit and causes issues. is anyone
Electronics Forum | Wed Sep 20 17:20:46 EDT 2006 | Stano
I have problem with Panasert MV2VB. After activation machine start up Windows NT normally, well near end initialization displayed message: MMI initial check - Symbol 1 - 0 error. After initialization finish and Power On machine is dispalyed Self diag
Electronics Forum | Wed Sep 20 17:24:35 EDT 2006 | Stano
I have problem with Panasert MV2VB. After activation machine start up Windows NT normally, well near end initialization displayed message: MMI initial check - Symbol 1 - 0 error. After initialization finish and Power On machine is dispalyed Self diag
Electronics Forum | Mon Jan 15 21:54:19 EST 2007 | raychamp007
Dear Friend, Our SMT Production & component ware house RH currently control limit set to 40%RH - 60%RH, but not always achievable, the RH reading measurement are between 38%RH -65%RH. J-STD-001D recommend 30%RH - 70%RH. However it is only a recommen
Electronics Forum | Tue Jan 23 12:22:12 EST 2007 | Grant
Hi, I ran a clean room once, and the humidifiers were built into the exit air ducts, and controlled by a humidity control unit that kept things at 60%. We were loading VHS tapes, and needed to keep humidity at that level or static discharges caused
Electronics Forum | Wed Jul 09 18:25:32 EDT 2008 | jmelson
There are temperature controllers that can be configured for a "safety stat" mode, so they blow a fuse to the main heater control if it goes, say, 10C or some reasonable fluctuation above the setpoint. It might be a VERY reasonable thing to add to y
Electronics Forum | Wed Sep 03 12:44:34 EDT 2008 | Bob Douglas
When considering MSD issues two factors really need to be focused on; first, environmental control of the individual subject component/s during storage and second, monitoring of the packages out of the controlled environment. It's important that eac
Electronics Forum | Mon Jul 25 14:31:11 EDT 2011 | davef
The imperative is for proper material control to assure: * No improper mixing of defective items with non-defective items. * Agreement on the definition of the next steps to be taken to correct the defective condition. * Agreement that corrective ac
Electronics Forum | Tue May 20 04:34:59 EDT 2014 | sarason
Well that would be a response from the VME bus. Is the PCBoard, the only controller on the buss, or is there a second controller that talks to interface boards etc. If so you might just have a problem with the second controller. Check the control sig
Electronics Forum | Sat Aug 08 09:45:11 EDT 2015 | edwaterfall01
It would be helpful to know what happened before the error occurred. Do you have another machine so that you can swap some boards? The Force CPU, (machine controller) located in the VME, is responsible for controlling all machine-related activities.
