Electronics Forum | Thu Jan 22 19:01:27 EST 2009 | smt_guy
To close the issue: PCB Fab had a look on the PCB's then decided to recall them back...including PCB's that's already been built... cheers!
Electronics Forum | Fri Jul 24 05:55:33 EDT 2009 | rway
Thanks everyone for your replies. We have decide to stay with the M1 system (top-down only). I appreciate your input. Reese
Electronics Forum | Tue Aug 18 15:36:40 EDT 2009 | davef
There is no standard. You need to decide when you want the cost of bad boards applied to your product cost. Search the fine SMTnet Archives for previous discussions, like: http://www.smtnet.com/Forums/Index.cfm?CFApp=1&Message_ID=20871
Electronics Forum | Wed Nov 18 14:09:28 EST 2009 | cyber_wolf
Please let us know how a 10-15K Quad 2C works out for you if that's what you decide on.
Electronics Forum | Fri Aug 27 14:33:09 EDT 2010 | mikesewell
The machine is intentionally leaving them off because its feeling an age bias? Or decides to drop them after vision on the way to placement, or...? What's the root cause? Just curious...
Electronics Forum | Sun Oct 17 23:07:04 EDT 2010 | Jack
Thanks Florin Yes, XD7800NT950 is capable to inspect our such big board. And, there is local distributor,too. now, we decide to check with Viscom and Dage. Thanks you again. Good days ahead.
Electronics Forum | Mon Oct 18 09:36:30 EDT 2010 | jamyboy
Thank you very much I will shoot you an email shortly. Funny that the 2 you mentioned are the 2 we are trying to decide on.
Electronics Forum | Fri Nov 19 08:03:18 EST 2010 | theo
Can anybody tell me what kind of anti-seize compound to use in a lead free solder pot? I have found copper, nickel, and silver anti-seize but I cannot decide which one to use. Thanks for the help.
Electronics Forum | Fri Jul 15 15:19:16 EDT 2011 | dan_ems
Have somebody experience with profiling vapor phase? I must buy a profiler and is very hard for me to decide what to buy. Please help me with a advice. Thanks you.
Electronics Forum | Thu Sep 29 07:14:41 EDT 2011 | williamaxler
I am trying to decide what type of no clean flux I should use in our selective solder machine. We run both leaded and lead free and would like to use the same flux for both. What is everyone else using? Or do you have any recommendations?