Electronics Forum | Tue Feb 22 17:03:48 EST 2000 | Chris
Dek 249 and Dek 260 models use to have fiducial recognition where table would adjust to the stencil. However, I would still recomend you buy an inline model because the change over will be much faster. Probably 10 times faster.
Electronics Forum | Tue Jul 13 13:58:50 EDT 1999 | JohnW
| We are looking to automate the paste printing portion of our SMT process. We are looking at used equipment from DEK and MPM from 1994 onward.(DEK 260 & 265 MPM AP20 & AP27) Does anyone have some feedback or concerns with any of these machines? Does
Electronics Forum | Mon Feb 20 17:56:46 EST 2006 | Chris
If you are running FR4 PCBs and not something exotic like Kapton flex circuits, I would go with the Dek 265 any day of the week. You will find that Dek supports the fully automatic printer much better than the semiautomatic printers like the 260, 24
Electronics Forum | Tue Jul 13 16:50:20 EDT 1999 | Boca
| We are looking to automate the paste printing portion of our SMT process. We are looking at used equipment from DEK and MPM from 1994 onward.(DEK 260 & 265 MPM AP20 & AP27) Does anyone have some feedback or concerns with any of these machines? Does
Electronics Forum | Tue Jun 30 12:08:55 EDT 2009 | wrongway
sipad does work we used it on one assy it had a very fine pitch part on it and at that time our dek 260 wasn't up to the task along with our 8 mil stencils. we had no problems with it it was sticky enough to hold the parts on thur all smt machines.
Electronics Forum | Mon Aug 18 10:42:04 EDT 2008 | floydf
We are in the process of preparing for a new board that requires paste in hole processing. The hole is a .020" via, and our customer wants it filled with solder, but not bulging past flush. For printers,we use a DEK 249 with a squeegee, and a DEK 260
Electronics Forum | Sat Jan 14 18:07:15 EST 2006 | Sona
I am looking for someone on the East Cost to service the following equipment. Electrovert EPK and DEK 260. We need to also add some convection heaters on the wave machine. We are located outside Philly, Pa If anyone can provide me with this info I a
Electronics Forum | Fri May 09 16:30:47 EDT 2008 | wrongway
we had a 1995 dek 260 in 2005 we bought a ekra X5 these two machines wre not alike at all but our ekra has been performing very well for us we run at least 2 shifts 5 days a week. have had to change couple of switches and tighten a belt and a new po
Electronics Forum | Wed May 18 18:36:22 EDT 2005 | global
Ok here's one for ya. We have a DEK 260 with a Cyberbectic vision system, 1 of about only 50 made as told to me by a DEK service Tech. So if anyone has operated one of the other 49 you may be able to help. The Service techs at DEK are not familiar en
Electronics Forum | Tue Jul 13 14:03:33 EDT 1999 | Earl Moon
| We are looking to automate the paste printing portion of our SMT process. We are looking at used equipment from DEK and MPM from 1994 onward.(DEK 260 & 265 MPM AP20 & AP27) Does anyone have some feedback or concerns with any of these machines? Does