Electronics Forum | Fri Feb 05 12:25:37 EST 2010 | baildl632
Yes, it's powered up. We use a simple power supply that connects directly to the drive. It spins up fine. I belive my problem is with Windows not recognizing the old type of drive correctly. It does recognize it as a mass storage device (the drivers
Electronics Forum | Fri May 26 13:16:53 EDT 2000 | Todd
I have worked with MPM and GSP (fuji) and the DEK. I have had the least problems with the DEK. Kept having software issues with the MPM although I have heard some having good experiences. We used the GSP for the through hole but needed new vaccum
Electronics Forum | Tue Jan 21 08:49:42 EST 2020 | emeto
I am sure you can upgrade it with DEK and it should not be so expensive. You can also ask them the price of the auto system. This is an arm(controlled by cylinder I think) and software to control it. This one moves the stencil in place when you load
Electronics Forum | Wed Dec 13 08:54:28 EST 2017 | raymccomb
We have a DEK 265 and we have fitted new belts to it after one split in use. when we set back up and run program A all is OK, when we go to run program B it has System Error. Servo Following Error - Fatal Error - Reinitialise machine. Does any one h
Electronics Forum | Fri Jan 17 09:34:22 EST 2020 | emeto
It looks like you have a simple version of the Horizon. You should have a scale on the right side with a stopper. When you create a new program you will define where the stopper should be. I used to same this value in the program description field, s
Electronics Forum | Mon Dec 06 00:44:45 EST 2004 | donb
You probably have already done this... but you need to enter the maintenance program with the maintenance key, select "Set Prefs" scroll down to "Upline Machine" and enter "Fuji".
Electronics Forum | Thu Mar 22 10:11:47 EDT 2012 | menatech
if you download the mint program (maintance key switched and download via auto mode. Does is read the card correct and does it identifies the correct motor encoder?
Electronics Forum | Tue Mar 20 05:03:47 EDT 2012 | sunyb123
Dear sir, i have face same problem of motor Communication fail Card0,Card1,I Clean Whole card properly, change the battery new one ,reprogrammed mint, but Card 2&Card3 loaded the mint programmed but not in card 0 & card 1, Please suggest what to d
Electronics Forum | Sat Nov 09 21:57:00 EST 2019 | dekhead
Not to be disagreeable, but sounds like "RichC" is describing earlier series 265 calibrations... (based upon location of PSR Amp and magnets to bypass cover interlock a 265MK1 (v. 1992-94). That "readings" calibration on your mach
Electronics Forum | Wed Nov 26 11:29:49 EST 2008 | floydf
The password on our DEK 260 is DEK1. Hopefully that will work on yours.