Electronics Forum | Tue Jul 14 15:26:06 EDT 2020 | dekhead
Not as straightforward a question as you might think... due to the multiple rail systems (at least 4) used on Europa. But what you seem to be describing is the single stage conveyor, which uses same belt as used on the GSX, and majority of Horizon /
Electronics Forum | Wed Sep 17 21:27:30 EDT 2008 | dekhead
I'll put a vote on MyData, but you might have problems with the volume... If you're buying used on this better off buying from MyData, they have a tendency to buy up the decent stuff off the used market, and anything left noone really wants to deal w
Electronics Forum | Tue May 27 15:11:13 EDT 2014 | dekhead
1. Rising Table Position error is, most commonly an issue of motor movement or sensor(s); Not receiving an expected input (sensor input / 'DONE' signal) in expected period of time. Try homing table in Diagnostics see if it moves and what movements ar
Electronics Forum | Sat Sep 16 17:11:08 EDT 2006 | dekhead
The 248 is a good machine, but I would look at a used one (the CE or CER package)... The latest (the CERD) is a nightmare as far as servicability (pretty cover package, impossible to get into to work on)... and the software (if it is a non-vision mac
Electronics Forum | Sat Sep 16 15:47:08 EDT 2006 | dekhead
95% possibility to the ballscrew... which is no ones favorite to replace. As far as the table situation now. I'm guessing that you have verified that the motor has power and the brake is not engaged. Does it still give a position error? or does it g
Electronics Forum | Sat Sep 16 16:02:19 EDT 2006 | dekhead
You are as close as you can be to verified... my 95% being an understatement... In a world (and a machine) where there are no absolutes... it's as good as it gets. I can't offer absolutes... without going over things that I might consider obvious bu
Electronics Forum | Tue Sep 19 10:30:54 EDT 2006 | dekhead
I think you may be remembering wrong. Timer circuit will normally cause table drop when system power is re-applied, not when it is removed.
Electronics Forum | Thu Feb 22 20:35:54 EST 2007 | dekhead
Your vocabulary is improving Tim
Electronics Forum | Thu Feb 22 22:01:18 EST 2007 | dekhead
Software version running? Is this on one product or all products? Left to right feed? If yes, is board at left sensor being keyed? Right to left feed? what is setting for "right feed delay", increase it?
Electronics Forum | Thu Feb 22 22:57:59 EST 2007 | dekhead
What software version is running? Assumption it is running with FMI, what is UL protocol? Change UL protocol to "Manual", belt should not start running until board is placed over sensor, confirm! All products or just 1? What is board width of curr