Electronics Forum | Tue Mar 24 09:48:15 EST 1998 | Steve Schrader
| Do you know if there is an IPC standard or industry standard | that addresses the proper process for handling MSD's in the production environment....? (rework etc.) | Not the receiving area. | Thanks so much, | Robin Arnold | PCB Development | Har
Electronics Forum | Tue Dec 04 09:48:43 EST 2001 | davef
Defining the thickness of solder between the lead and the pad, J-001 states "Properly wetted fillet shall be evident." J-001 is available from http://www.ipc.org. Factors that affect this are: * Amount and composition of solder * Amount and compo
Electronics Forum | Fri Apr 12 15:48:33 EDT 2002 | jersbo
SPC for each assembly(I use C(for board defects)NP(for unit defects) at the end of reflow to determine process capabilities determine Control limits. Once control limits are set, inspectors stop the process until out of control limit is addressed and
Electronics Forum | Wed Sep 18 18:48:33 EDT 2002 | davef
Fabs can produce a solder mask web between 20 pitch leads, but I've never seen a web for 16 pitch leads. Although, I would like know a supplier that can lay-down a fine web. Minimum solder mask web width is about 0.004 thou. An absolute mininum o
Electronics Forum | Mon Oct 21 23:48:13 EDT 2002 | harris
Hi: If anyone have the experience with the PCB pad design and stencil design for the uBGA? We meet the problem for it. The component data is 0.3mm diameter and 0.5 pitch. Could anyone tell me the PCB pad dimension, the stencil type and aperture dimes
Electronics Forum | Wed Jul 27 16:46:48 EDT 2005 | russ
I don't think that you would need to test these. Have you ever seen any evidence of solder sticking to them? We use the same material and never notice anything besides flux staying on the bottom. Would the lead absorption if any even be of a concer
Electronics Forum | Thu Nov 13 22:20:48 EST 2008 | davef
For your pad layout and spacing between components, look here: http://portal.ipc.org/Purchase/ProductDetail.aspx?Product_code=77b562c1-b8f8-db11-8a6a-005056875b22 For your standoff height in SMT, we do not concern ourselves with standoff height. It
Electronics Forum | Mon Jul 13 13:48:37 EDT 2009 | christian01976
Hello! You can check your vacuum in MANUAL and then VACUUM IN MONITOR. You can switch the vacuum on or off for each head. With a TYPE 72 nozzle and no component the vacuum should be around 80 or 90 and with a component at the nozzle it should be ove
Electronics Forum | Sun Jun 14 15:40:48 EDT 2015 | csm
Dear All We are looking some Phillips Technician can do programming for FCM-2 equipment and we are looking the Programming manuals and maintenance manuals. Can somebody help us, or can give us support to give maintenance and programming to some FCM
Electronics Forum | Wed Jan 09 17:14:48 EST 2002 | mregalia
Do you bond with Al or gold wire? What happens if the Ni is over 150 microinches? Thickness of nickel is one those things that we have not been consistent with. The industry seems to pretty much universally call for 100-200 microinches. Our old board
