Electronics Forum | Thu Aug 30 13:22:47 EDT 2001 | arzu
180deg More important are the preheat and soakzones and temp ramps. How to check: I used to do it as follows: use a TEST-PCB with fixed thermocouples and connect it to the mole. Print the profile on transparant paper. do it again e.g. each week and
Electronics Forum | Thu Jan 20 22:26:50 EST 2005 | fastek
I have people ask me on occasion how many hours an oven has run and for the life of me can't figure out why they would want to know that. Who cares? They work until they don't...not much middle ground...unlike a chipshooter which will reach a point t
Electronics Forum | Fri Jan 21 13:39:15 EST 2005 | Chunks
Directors and company owners care since they're buying it. It's like an odometer on a car - just an indicator. But like your chipshooter example, moving parts on an oven wear out too. They just don't stop working. Plus they're subjected to higher
Electronics Forum | Mon Oct 13 09:42:56 EDT 2003 | rmurtuza
How can I acquire an operating manual for the Electrovert Electra Wave Solder Machine
Electronics Forum | Thu Mar 23 23:21:10 EST 2006 | AR
100 cm/min) the motor runs without complaint. Too bad we run the conveyor as slowly as 10 cm/min... I'll try replacing the control board next when I get my hands on one.
Electronics Forum | Thu Mar 23 07:55:10 EST 2006 | Peter
We had the problem for � a year, and cleaned everything. We replaced the DART-control unit, and have not seen the problem since
Electronics Forum | Tue Oct 22 11:21:08 EDT 2013 | omur
We have an Electrovert 10E - and the harddisk died a week ago. Unfortunately, we do not have the installation diskettes anymore. Can someone help with these diskettes or CD's ? Thanks in advance. Omur...
Electronics Forum | Wed Sep 02 11:52:40 EDT 1998 | Dick Casagrande
We are investigating equipment for a new SMT line. We are an OEM doing thru hole assembly and now must decide whether to do SM assembly in house or sub-contract out. We are a low volume/high board mix company. Our boards are mixed tech with SM on bot
Electronics Forum | Sun Sep 06 12:46:22 EDT 1998 | Phillip Hunter
| We are investigating equipment for a new SMT line. We are an OEM doing thru hole assembly and now must decide whether to do SM assembly in house or sub-contract out. We are a low volume/high board mix company. | Our boards are mixed tech with SM on
Electronics Forum | Mon Jan 19 08:37:16 EST 2009 | lkpdsund
Hello all! We possess a speedline electrovert omniflo 7 reflow oven at my site. Last week we examined how the solder profile was affected by fan-speed and by providing the soldering process with compressed air(O2) or nitrogen(N2). We also ran the sa