Electronics Forum | Fri Nov 07 18:14:17 EST 2014 | cot628
That is a lot of Mydata lines to place billions of parts.
Electronics Forum | Fri Nov 07 18:12:50 EST 2014 | cot628
This issue is coming from a customer. The customer demands that we do not mechanically center or test passive components, because of issues they had in the past. There has been a studies that it takes about 8-10 newtons to damage chip. Most of our pa
Electronics Forum | Sat Nov 08 00:28:25 EST 2014 | padawanlinuxero
Hello We a Mydata and put all kinda of components with the midas unit, but never had problems with ESD, and some of them are very delicate parts, perhaps like our colleague said perhaps you should look at the trays or feeders that you are using, pe
Electronics Forum | Mon Nov 10 06:54:19 EST 2014 | cyber_wolf
It's called running every day 3 shifts for 22 years. Anyway....My precise numbers aren't handy but lets just say a lot of parts were placed in that time. I would be pretty confident in saying that the centering jaws do not cause ESD damage on Mydat
Electronics Forum | Mon Nov 10 09:11:51 EST 2014 | rgduval
The centering jaws are made out of copper, I believe...and conductive. I'd suggest that the conductivity of the copper makes it a fairly poor source of ESD damage in a component. I have observed physical damage to components from the centering jaws
Electronics Forum | Thu Nov 10 23:09:45 EST 2005 | davef
Poured flooring suppliers are: * Garland Floor http://www.garlandfloor.com * Sauereisen http://www.sauereisen.com/c_prod/c_esd.htm Vinyl & rubber flooring suppliers are: * VPI http://www.vpiflooring.com/products.php?cat=2⊂=1 * 3M http://products3
Electronics Forum | Fri Jan 28 14:53:29 EST 2011 | bandjwet
Dear SMTNetters I have a fairly large pile of different size ESD part trays that we collect over time from clients. The jobs have long since come and gone. Does anyone have any ideas on who to trade/barter with to get them out of our plant? Regar
Electronics Forum | Tue Oct 12 13:03:18 EDT 2021 | cunningham
Afternoon all, Do you use any special surface other that ESD matting when changing over matrix trays? We currently use a earthed wire trolley that we keep trays and MSD bags on and when replenishing stock its carried out on the trolley. Does anyon
Electronics Forum | Wed Oct 10 14:21:04 EDT 2007 | petep
We have done the Green Framed Stencils for an added $50.00 per, then got smart and went to green polyester on RoHS / Lead Free Stencils at no added cost. Dedicated Stencil blades and holders green of course) as well as Green Static mats on dedicated
Electronics Forum | Wed Aug 07 11:55:31 EDT 2002 | slthomas
Ron, have a look at http://www.fda.gov/cdrh/dsma/cgmphome.html It would be a nightmare, if your plant is not structured to support it. It's a huge pain in the fanny even when you (alledgedly) are. I'm not sure what you're pursuing, but if you're c