Electronics Forum | Thu Jun 19 15:40:13 EDT 2008 | patrickbruneel
An excellent summary of the facts and the insanity of the lead-free legislation http://www.sigcon.com/Pubs/news/10_01.htm
Electronics Forum | Mon Aug 11 10:38:06 EDT 2008 | thaqalain
Well first 6 out of 180 were right and acceptable RTI result was supplied too late, I was busy on inspection and the technician was out of RTI station. I have deatiled data sheet (17 pages) with all facts and figures, will I forward it to you?
Electronics Forum | Thu Sep 25 17:37:54 EDT 2008 | gregoryyork
Best is 7 or 6.5D if you cant achieve 7. In fact this is the best angle for Leaded and Lead Free, so watch the Chinese machines as they come in around 5 and cause loads of bridging problems
Electronics Forum | Thu Apr 09 18:55:49 EDT 2009 | gregoryyork
seen it many times before when the resist is not cured at manufacturing. get PCB man to check with K type thermal couple that boards ARE in fact cured. this is normally 155C ON board temperture not oven setting Cheers Greg
Electronics Forum | Fri May 29 00:34:17 EDT 2009 | operator
Thank you Dave. I have searched the internet and cannot find any literature to the fact. Do you have knowledge of of any articles, whitepapers, etc... Thanks again, B
Electronics Forum | Thu Aug 06 12:46:15 EDT 2009 | jorge_quijano
Yes, it is centered, in fact is the same product we run everyday, problem shows up after maintenance was performed.
Electronics Forum | Tue May 04 14:45:40 EDT 2010 | bruna
Hello Does anyone can give feedback about this two analyzers (zirox and delta f 150)? In fact we are trying to understand which is better for wave soldering, benefits and prejudice. Does anyone work with both? Thanks
Electronics Forum | Fri Apr 22 14:19:29 EDT 2011 | cbeneat
Patrick, It actually seems to go away after every adjustment. Whether it's flux, heat, doesn't matter but it always reappears. The part that has me baffled is the fact that another identical part is approx. 4 mm away, and never affects this one.
Electronics Forum | Tue May 10 17:26:02 EDT 2011 | jamike
hmmm I don't think i'l get away with that one, the staff do not grasp the fact that if we do not maintain an acceptable efficiency their jobs are at risk to going to Asia or the company folding completely.
Electronics Forum | Thu Jul 21 11:13:25 EDT 2011 | kahrpr
we use turtle wax on a more serous note, I bet those two products are similar in the fact it you fill the ridges in the aperture walls you will get better release. They may be closer than you think.