Electronics Forum | Thu Mar 02 20:06:51 EST 2023 | kumarb
Thanks for your comments. The table aligns fine but just makes the whining / ticking sound when using the 'REFERENCE' command. In this command the table moves more than the live 'AUTOMATIC' mode. The motors are working fine to align the PCB & stenci
Electronics Forum | Thu Apr 04 16:38:51 EST 2002 | davef
Equipment companies like to talk about �accuracy� and �repeatability�. These measures provide limited information. Flaws of the measure aside, some printer companies have begun to report Cp. * DEK ELA: Cp = 1.33 @ �0.025mm * DEK 265: Cp = 1.6 @ �0.0
Electronics Forum | Thu Jun 26 14:25:19 EDT 2008 | jax
Current Acceptable HMP Soldering Methods: 1. Wave / Selective Solder: Some Brands require upgrades to heating elements and Pot materials 2. Laser: Works well with PTH and medium/large passive SMT. Damage to PCB masking can occur when try
Electronics Forum | Sat Mar 12 18:32:29 EST 2011 | jlawson
It is pretty hard to wave solder fine pitch parts bad enought with 0.5mm let alone 0.4mm It can be done but need N2 inert wave soldering & need layout design to accommodate this... Iy it is a QFP need to run part 45 deg into wave and if possible in
Electronics Forum | Tue Oct 01 16:18:16 EDT 2002 | davef
Q1: Is this [paste in hole] feasible? A1: Yes, many people lower their operating cost by reflowing through hole components. Q2: What types of components are difficult to do this way [paste in hole]? A2: Types of through hole components that are d
Electronics Forum | Mon Apr 07 12:21:02 EDT 2003 | davef
Russ is correct. A 5 thou thick stencil should give good release. Here's how you run through it: * You want at least 5 solder particles across the smallest aperture. So in your case, 8 thou wide, which equals to 0.20mm gives us 0.20/5=40 microns.
Electronics Forum | Thu Sep 23 11:56:30 EDT 2004 | rkevin
We are printing on an assembly using SAC305 Alloy Sn96.5 Ag 3 Cu .5 with a no clean flux and getting virtually NO spread with either a ramp to spike or straight ramp profile. We are printing to standard FR4 board with immersion Ag finish. I am trying
Electronics Forum | Sun Jul 08 06:38:41 EDT 2007 | dilogic
We have an old GSM1 (I-block, USOS V1.4.14, two 4-spindle heads, changers between rails). When I configure machine so there are no nozzles on heads and changers are filled with required nozzles, except for one empty hole, machine won't pick up nozzle
Electronics Forum | Wed Apr 11 17:00:28 EDT 2012 | rodrigo
Hi all, Our cp4 moves rather violently (jerks) all axis when the reset sw is pressed after power up. I've got all sorts of errors after boot up: Servo amp error: D,X,Y, etc Overtravel D,X,Y, etc D clutch error, power off machine We've checked all
Electronics Forum | Thu Mar 14 13:48:18 EDT 2013 | cyber_wolf
The entire oven is clean there are no blockages and the heater plates are brand new. I have worked with Vitronics technical support and gone through this thing with a fine tooth comb. I have even gone as far as to compare the exhaust and intake cap c