.JPG)
New Equipment | Industrial Automation
Contact: Nancy Lin Email:info@amikon.cn Skype:onlywnn_1 Telegram:+8618020776786 Mobile(Whatsapp): (+86)-18020776786 QQ :2851195456 Control Systems (DCS, PLC/SPS, CNC) - Panel Controllers - HMI and Display Panels - Industrial PC’s - Drives (
& D AD-4714A INFRARED MOISTURE DETERMINATION BALANCE A & D COMPANY AD-4316 INDICATOR A & D COMPANY AD-4322A INDICATOR A & D COMPANY AD-4323 INDICATOR A B DICK SEE VIDEOJET A B DICK 84-100-00/B MODEL 1200 ENVELOPE FEEDER BD A C
& D AD-4714A INFRARED MOISTURE DETERMINATION BALANCE A & D COMPANY AD-4316 INDICATOR A & D COMPANY AD-4322A INDICATOR A & D COMPANY AD-4323 INDICATOR A B DICK SEE VIDEOJET A B DICK 84-100-00/B MODEL 1200 ENVELOPE FEEDER BD A
A & D AD-4714A INFRARED MOISTURE DETERMINATION BALANCE A & D COMPANY AD-4316 INDICATOR A & D COMPANY AD-4322A INDICATOR A & D COMPANY AD-4323 INDICATOR A B DICK SEE VIDEOJET A B DICK 84-100-00/B MODEL 1200 ENVELOPE FEEDER BD A C HAMI
5.jpg)
New Equipment | Industrial Automation
Contact: Nancy Lin Email:info@amikon.cn Skype:onlywnn_1 Telegram:+8618020776786 Mobile(Whatsapp): (+86)-18020776786 QQ :2851195456 Control Systems (DCS, PLC/SPS, CNC) - Panel Controllers - HMI and Display Panels - Industrial PC’s - Drives (
Electronics Forum | Wed Feb 19 09:52:45 EST 2014 | brendansales
Dear Rob, Got to the maintenance menu, under the Motor section, I selected Z motor and tried to initiate motor, there was no movement on the machine and I had the error message as below: F-MOT-MSETDYN Z/12: Position counter dead I suspect that ser
Electronics Forum | Thu Feb 13 00:43:06 EST 2014 | brendansales
Centering motor about to fail or has failed. > Centering motor about to fail or has failed. Hey Rdubya, Thanks for your help! Apparently that was not the problem. The Midas head had to be all the way down below the lower locking solenoid. After
Electronics Forum | Tue Feb 11 14:42:49 EST 2014 | rdubya
Centering motor about to fail or has failed.
Electronics Forum | Thu Feb 13 09:52:03 EST 2014 | rgduval
Start by getting into the maintenance menu, and manually installing the Servo program for all MOTs. If they install fine, you can check the Z-motor while you're in the maintenance menus. Make sure that the z-locks are unlocked before checking the
Electronics Forum | Thu Feb 20 13:16:15 EST 2014 | rgduval
Hi, Brendan, It sure sounds like it to me. But, with the Z axis, there could be one other thing to check. On my old TP, there were z-locks...two pistons that pointed sideways around the head travel. Initializing the z-motors did not move the z-
