Electronics Forum | Tue Jul 02 11:04:20 EDT 2019 | dman97
The pin outs are not mirrored. The proper data files usually come on a disk and are usually inside one of the cabinets on the machine. Chances are that the proper data disk is MCS formatted. In order to extract the proper data from the disk you woul
Electronics Forum | Fri Dec 08 17:31:17 EST 2023 | madisreivik
Changed camera, flicker is gone. But cannot calibrate nozzle centers with the narrow camera, error all time I checked buffer image, brightness and contrast is SAME as with wide camera. Center of camera is roughly aligned using nozzle, its better
Electronics Forum | Wed Dec 06 17:22:03 EST 2023 | madisreivik
Hello and help ! After changing oil hose, cleaning machine and all nozzles, CP642 narrow camera started to flicker. And in nozzle centering measuring, no image at all. We checked syncro pin, seems ok. Also checked camera picture with Sony monitor,
Electronics Forum | Fri Jun 22 11:02:13 EDT 2007 | gregf912
I have a CP642E machine that will not function if auto adjust is enabled in Part Descriptor. Symptom: Auto pick offset causes machine to pick part off center to the point of going to end of part after several picks. This only happens to parts that ha
Electronics Forum | Wed Apr 22 12:50:39 EDT 2020 | rodrigo
Hi all, One of our Fuji CP-642 machines has a weird problem. It does not happen every time but often enough that it is a problem. I power up and press start to zero it. The problem is the zero...ing does not finish. It moves the xy-table, D1/D2 table
Electronics Forum | Fri Dec 15 20:51:01 EST 2023 | cyber_wolf
Calibrating the cameras on these machines is not something you can do "correctly" without the jigs from Fuji and following an exact method. It's been years since I watched a Fuji FSE do this, but I can assure you that unless it is done EXAC
Electronics Forum | Tue Feb 26 05:52:35 EST 2002 | mustservices
basically i am looking for a list of parts that would be required to be changed in an annual service for the qp242 and cp642. this information will not be relaeased by astro or fuji america or fuji japan as we are a competitior to astro in the uk, so
Electronics Forum | Tue Feb 26 05:56:14 EST 2002 | mustservices
basically i am looking for a list of parts that would be required to be changed in an annual service for the qp242 and cp642. this information will not be released by astro or fuji america or fuji japan as we are a competitior to astro in the uk, so
Electronics Forum | Fri Nov 01 17:32:34 EDT 2013 | dhruv_trylene
I am sorry for not being clear enough... We have a FUJI CP642 and a IP3 machine. At present, we have to create part data for each and every part used in a job, which consumes a lot of time. I was just wondering if there was a way to minimize this?
Electronics Forum | Tue Sep 07 21:30:24 EDT 2004 | peter016
I would like to know what are the achievable chip placement per hour for the following chipmounter models. 1. Siemens HS50 (Spec at 50,000 chips per hour) 2. Siemens Siplace S20 3. Fuji CP 642 4. Sanyo TCM1050 5. Universal HSP4975(re-badge of TCM3000