Electronics Forum | Wed Jan 30 12:22:06 EST 2002 | jax
Clark, The universal GDM should handle your application with ease. Although not as accurate as an archimedes screw, the positive displacement pump of your GDM will still be well within any tolerances if maintained and operated properly.. Not to me
Electronics Forum | Tue Oct 13 12:32:43 EDT 2009 | davef
2.6.3 Test Pad Location Tolerances, third bullet. Why does Entek require different test point spacing than other surface finishes? Page 55, top image is off the page, partially. 2.3.6 Depanelization of Arrays, 10th bullet [Breakaway Scoring] refers
Electronics Forum | Tue Jun 18 03:16:46 EDT 2013 | mun4o
production lot is 4000pcs.About 70% of capacitors are out of tolerance ( +/-20%).There are 3pcs C=10u per PCB, in different location.Samsung capacitors wich we use are 1,5 years old - i checked this information from our supplier " Rutronik ".I have
Electronics Forum | Mon Aug 20 09:58:58 EDT 2018 | grimus
This is interesting Alexei. So Flex is able to check my complete project before I decide to start manufacturing process, and advice me what should I change to minimize quality and assembly issues? I'm really interested in finding such service. Do the
Electronics Forum | Fri May 27 14:22:47 EDT 2022 | proceng1
I am not exactly clear on what you are looking for. From my customers, assembly drawing notes are assembly specific. If there is hardware, they might include the stack-up. If we are conformal coating, they usually indicate keep-out areas. If an LED
Electronics Forum | Wed Oct 25 02:09:43 EDT 2000 | keith_hodgson
We are using a Universal GSM to place Densipaks.Unfortunateley every so often we hit a spell were the Densipak is raised because either one or both of the locating posts on the Densipak has not located correctly in the hole. These are very hard to re
Electronics Forum | Wed Sep 08 20:38:06 EDT 1999 | Barbara
I have a board that has surface mount on both sides . On this board is a 22pin connector which is the only thru-hole part.This part is located on the component side. I would like to reflow this part. Can this be done? If so, how can this be done?
Electronics Forum | Thu Oct 15 10:26:13 EDT 1998 | Dave Celestian
I have a problem with measling on our PCB's. We saw it on our FR4 PCB's at final assembly yesterday. Is this a defect from the board vendor or something we did in our assembly process when building the PCA's (thru hole). Could the wave solder mach
Electronics Forum | Mon May 11 16:09:07 EDT 1998 | Todd N
We are having continuous bridging problems with the trailing leads on a 26-pin D-sub through-hole connector. The pitch is 0.100". The connector is going through the wave at approximately a 20 Degree angle. Does anyone have any board layout recommend
Electronics Forum | Mon Jun 29 15:52:00 EDT 2020 | jmelson
One last question, can the FLX2011 pick up a negative fiducial, ie. a plated through hole? Some of my boards do not have traditional fiducials, so I pick up the location of a couple mointing holes. (It didn't address this in the documents.) Thanks