Electronics Forum | Thu Mar 30 21:46:56 EST 2000 | Dave F
Reg: This is copy / paste from draft version of IPC 7095 ( issued May 1999 ) ... 7.3 Assembly accept/reject criteria 7.3.1 Voids in solder joint a. Sources of Voids There can be voids in solder balls, or at the solder joints to the BGA, or at the so
Electronics Forum | Wed Nov 03 14:46:29 EST 2004 | dramos1
Hi Russ, Thanks for the reply. In IPC-A-610 Rev. C on section 5.2.9 {Mounting - Connectors] page 5-21 on the manual [January 2000], the acceptable class [1,2,3]listed 3 items. In order for the connector to be accepted, are all 3 items must be met? I
Electronics Forum | Wed Mar 17 19:41:15 EST 2004 | Dreamsniper
I'm hit with the above problem and found out that the BGA's themselves have fibres on their solder balls. I have soldered some without having the knowledge of the above fibres and found that the fibres are caught between the PCB pad and the BGA solde
Electronics Forum | Thu Oct 26 16:38:08 EDT 2000 | Philip A. Reyes
Hi Sir Charles! Good Day! I hope you can help me about my queries. 1. What is the acceptable misregistration or misalignment of balls after reflow soldering of PBGA module on the PCB? 2. Is there any criteria for solder ball defect or solder beads
Electronics Forum | Sun Jul 29 09:17:20 EDT 2001 | davef
Tough to say, but ... Chlorine: Many fluxes contain chlorine. Sulphur: Many solders and paper packing materials contain sulphur. Sodium: No idea. IPC-J-001 talks to board cleanliness and specifies criteria according to the cleanliness test met
Electronics Forum | Wed Apr 28 14:58:39 EDT 2004 | davef
Solder ball acceptability: IPC-A-610, 6.5.3.1 & 12.4.10
Electronics Forum | Wed Nov 03 13:31:28 EST 2004 | russ
Could you give a specific example (sect. paragraph etc) that is giving you trouble? Russ
Electronics Forum | Wed Nov 03 09:18:27 EST 2004 | Simon UK
Hi Dennis, It is all dependant on what you state for the class of product i.e. Class 3 is the top end acceptance criteria used mainly in Aerospace and Military. You have 2 terms you need to grasp to avoid confusion. 1. Acceptance Criteria 2. Target
Electronics Forum | Fri Aug 21 13:43:13 EDT 1998 | Ben Salisbury
| Hello everyone, | I am currently running a gold plated SMT board and am experiencing tiny solder balls between the pads and the masking between the 20 mil pitch devices. I'm looking at these boards with a 60x microscope. IPC-610 say's any visible s
Electronics Forum | Wed Oct 20 13:53:22 EDT 2004 | Greg D
Hi, What's the maximum and minimum solder void that can be accepted during X-ray? What about the percentage of Ball Roundness..20%? 30%? thanks and regards,
IPC is the trade association for the printed wiring board and electronics assembly industries.
Training Provider / Events Organizer / Association / Non-Profit
3000 Lakeside Drive, 309 S
Bannockburn, IL USA
Phone: 847-615-7100