Electronics Forum | Thu Oct 04 13:34:02 EDT 2007 | rgduval
I'd be happy to tell my customers that they need to provide more parts...the problem is, we specialize in short runs. So, if the customer pinches pennies, and only buys 50 pieces for 50 piece demand, I need to be able to deal with it. Hence, the
Electronics Forum | Tue May 06 11:56:56 EDT 2008 | joeherz
We have a board that uses 0402x4 RNET packages that we are having a difficult time getting to solder consistently. Paste deposition is fine (using AIM WS353) and profile is dead-nuts. I'm starting to wonder if this is something that we're just goin
Electronics Forum | Wed May 07 15:36:04 EDT 2008 | llaerum
The 483 is what we use on all boards except on one where the 353 improved wetting on resistor packs. It worked much better since the parts are LF and this is the same flux AIM uses in their LF solder. Yes, it was recommended by AIM when we discussed
Electronics Forum | Tue Aug 12 15:34:37 EDT 2008 | grics
That is very interesting... I am curious though, why wasn't a plain blind rivet used? You probably can, but personally, I would be not want a solder joint holding the frame and the pcb... Mechanical stress on solder joints often leads to not good re
Electronics Forum | Wed Aug 13 09:20:05 EDT 2008 | wrongway
we tested this kind of part about 3 years ago did a few prototypes I did'nt know how it was going to work but our old amistar picked it and placed it just fine used a small nozzle with a o-ring on the end of it I think it did ok going across the wav
Electronics Forum | Fri May 22 08:04:30 EDT 2009 | stevezeva
Have any of you ever worked with Actel's QFN 180? A three row I/O QFN? Actel has a published paper on design and assembly guidelines, but we're finding that they are pretty much generic, and don't really work as well as they lead you to believe. ht
Electronics Forum | Tue May 26 15:39:16 EDT 2009 | mikesewell
Amkor's MLF guidelines are very similar to Actels. 1 to 1 on the stencil to part pad on the I/O pads, 75% with a grid windowpane, 0.125 mm/5 mil stencil. For example, the Actel area ratio for a 0.3 mm sq. pad and 0.125 mm stencil is 0.6 which seems
Electronics Forum | Thu Oct 27 20:37:49 EDT 2011 | tech1
the calibration error sounds like it is an electrical verifier issue. Are you testing parts before you place them? It could be that your centering electrodes are worn or dirty, or it could be the ribbon cables from the centering unit. If you are usin
Electronics Forum | Thu Mar 31 15:53:23 EDT 2022 | stephendo
And pin outs of both. Once I saw a SOT-6 replaced with a miniSOT-6 (IIRC) The pin outs of the two parts were different. We did make an adaptor board and it wasn't too bad. We populated a panel of the adaptor boards, depanelized them and put them in t
Electronics Forum | Mon Apr 30 18:17:16 EDT 2001 | ianlg
Hi Barry Unable to assist on specifics but I can tell you that some 74 100is machines were built. The majority residing in China Imported in by Wong King Kong Ltd ( Johnson lee Tel 00852 2357 8888 ) Most are at either Flextronics or Roslare. You mi
