Electronics Forum | Wed Jan 31 09:54:52 EST 2007 | FredC
Rob, I am not a Fuji technician, but I have some knowledge on the nozzles, windmills, and headshafts. As far as I know the bore the nozzle travels in should be dry with no lube. The grease on the windmill shaft and locating pin is a special purpose g
Electronics Forum | Mon Oct 05 10:29:38 EDT 2009 | cyber_wolf
I ended up finding that there were broken chords on the X-belt. I replaced it and all is good. Rob, Mydata is right. You can indeed end up spending lots of time and money trying to chase a transducer error. Things I would look at: 1. Lubing the X b
Electronics Forum | Mon Aug 20 05:45:18 EDT 2012 | bobpan
To solve your problem....you should do the following: 1. Super Lube the o-rings on the z-rod bellows. 2. Make sure your head to camera calibration and head to head calibration is good. 3. Line up the nozzle changer pocket positions. 4. Make sure you
Electronics Forum | Wed May 01 15:27:22 EDT 2013 | lheiss
Hi All, I've been using a IVc for many years. I'm to the point where I have Mod Code 8 = 15, MC9 = 500, and all Extents PU delays set to 40ish. These settings work pretty well but I would like to get them closer to factory defaults to save the los
Electronics Forum | Fri Jul 26 13:11:06 EDT 2013 | gallionc
I think we are all on the same page with this one. Since you ran from 96 until now without any issue I'd say that now you know what causes the problem, make a note of it for next time and move on. I have found with our older machines that "if it ai
Electronics Forum | Tue Jan 05 21:24:34 EST 2021 | rmitchell
We use to have to replace the "dog" tube when it got rounded out or worn a little. If you you already cleaned it and can see the red light going off and on when you gently push up on the nozzle it is just not seeing in time and it gives the nozzle c
Electronics Forum | Mon Mar 01 21:14:26 EST 2021 | davem
Hey Guys, so I have 3 Vitronics wave solder machines to care for (2 x 6622 and a Delta 5) and they're in need of some TLC. One thing they look to be badly in need of is some conveyor chain work. I found a thread here on chain cleaning, but wanted to
Electronics Forum | Fri Apr 10 06:21:08 EDT 1998 | Ben Salisbury
| Has anyone running the cp4-3 feeders (MC type) in 8 by | 4 td flavour seen excessive wear on the aluminum body | caused by the tape leaf cover and tape leaf retaining | clip?? Sorry for the delay in posting to this one... I have in fact seen this w
Electronics Forum | Thu Mar 04 19:27:33 EST 2004 | russ
what I have usually found although not from wave conveyor chains but from racing motorcycles is that binding is caused by wear and bending and not dirt unless it is excessive to the point that you can actually see the dirt that is binding it. When t
Electronics Forum | Tue Oct 26 10:49:00 EDT 2004 | Simon UK
Hi, > > I'm planning to get a new oven. I wanna > know the advantages and disadvantages of each > oven type over each other. I'm being told to go > for an 8 zone oven. > > thanks for your > help. > > regards, Depends really if you want a dua