Electronics Forum | Wed Aug 12 12:02:41 EDT 2015 | edwaterfall01
I think the heart beat message comes up if the vision had not initialized. You have changed that already stop I think it is something else. Have you some money a Restore of the Machine Configuration and Mapping and Calibration Data?
Electronics Forum | Wed Aug 12 17:41:15 EDT 2015 | edwaterfall01
Sorry for all the typos in the last message. As the machine was powered OFF for two weeks I would have expected a battery problem. Can you capture a Logicimm file and see what the file says before the heart beat messages?
Electronics Forum | Tue Jun 13 10:33:48 EDT 2017 | simons
Yes. All amps were properly programmed and tested with another Samsung machine. In addition head #1 Z-axis motor was also swapped out. Simon
Electronics Forum | Tue Jan 08 10:16:58 EST 2019 | bane016
Hehe it's nice to hear that you are satisfied with the machine..The only problems with the NPM that we had was filter full for now... Are you using auto changeover,automatic suportpins and material control?
Electronics Forum | Fri Feb 01 18:23:30 EST 2019 | slthomas
Is it indexing at the correct pitch when you push the forward button? I really can't remember much about those machines but it seems like that's an indication that it's not programmed correctly. I'll be bobpan knows, regardless. ;)
Electronics Forum | Wed Feb 13 18:13:58 EST 2019 | slthomas
I'm trying to visualize how that machine is laid out. Do they all rotate together, on a belt, so that there's only one sensor for the theta (R) home position?
Electronics Forum | Mon Nov 29 20:15:22 EST 2021 | erici
Thanks for the message. Yeah the machine was about to start-up when the problem happens. I will try your suggestions. Thanks again.
Electronics Forum | Sat Dec 01 18:08:03 EST 2007 | jmelson
Hello, I just ran into a crazy problem with my CSM84. I did a batch of one side of a board, then loaded the program to do the top side, and it stops with the head over the 3rd component's feeder, and reports error 117:overflow. The maintenance manua
Electronics Forum | Wed Jan 19 08:19:18 EST 2011 | tombstonesmt
I recently wrote a program on one of our > Pilarhouse Jade machines and receiving an error. > The machine has the feature of "Wave Height" that > I don't have enabled for a 2.5mm extended tip > nozzle. This is the only program that I haven't > u
Electronics Forum | Tue Jan 18 10:46:31 EST 2011 | tombstonesmt
I recently wrote a program on one of our Pilarhouse Jade machines and receiving an error. The machine has the feature of "Wave Height" that I don't have enabled for a 2.5mm extended tip nozzle. This is the only program that I haven't used this featur
