Electronics Forum | Tue Oct 07 03:03:06 EDT 2008 | rafacadiz
We had the same problem last year. You need verify these key points. 1- Holes are drill, NOT PUNCH. 2- Inspect 100 Boards at microscope, and verify that there is not rest of fibers in the holes. 3- Meassure the dimensions of the holes. a) virgi
Electronics Forum | Wed Feb 25 13:06:31 EST 2009 | exsydeco
well, you are rite about ppl that buy craps products like my previous company that scammed me to work for him for free does. he got most of the parts from china, a cheap one. Actually there are good supplier from china that provide high quality parts
Electronics Forum | Mon Feb 01 14:24:45 EST 2010 | boardhouse
Hi Jamyboy, I would find out from DDI what the 70% was rejected for, Could have been a repeat issue due to a scratch in artwork or something like that. I would not just jump and tell them to rebuild all until you know the facts. DDI is a very re
Electronics Forum | Tue Feb 02 08:50:20 EST 2010 | stepheniii
Is it possible the 70% are marginal and the board shop is being uber picky? I've seen a huge range of quality standards for board shops. And considering the cost of the boards I think a boardshop tour would be warrented to get firsthand knowledge o
Electronics Forum | Fri Mar 18 13:42:02 EDT 2011 | kahrpr
First thing try a different solder paste. All solder pastes are not created equal. Also if everything else on the board looks good then check the part. As far as nitrogen goes its about 4 bucket loads you need an external tank. I have seen some marg
Electronics Forum | Mon Feb 11 09:49:43 EST 2013 | marcelorotofrance
Well, i can divide the inaccuracy in two phenomenons: Poor repeatability, i.e. the pockets don't stop at the same position after every shot by a margin of up to 0,5mm (20mils). The second problem is the stop pocket position, which is not equal from o
Electronics Forum | Mon Aug 26 00:17:32 EDT 2013 | alexeis
Hi, After you got datasheets of component shapes (only new one) and enter it to SMT machine library (including Polarity Mark and Position), you can use our software to simulate and fix all angles. Also, our software has tools to add Polarity informa
Electronics Forum | Wed Jul 15 11:42:24 EDT 2015 | davef
Here’s what you should try: * Go to the “Used SMT Equipment” nav tab [left margin, upper part of this page] * Click “Add Item” button [weird orangy, peachy color button, right side, near top, above thick blue line] * Complete form, making sure that y
Electronics Forum | Mon Jan 25 17:58:22 EST 2016 | spoiltforchoice
I think its sufficiently niche that the only similar product is the Essemtec Scorpion, which is cheaper and slower. However depending on just how low volume you are Essemtecs platform can also pick and place on the same machine (albeit with few jet n
Electronics Forum | Tue Aug 30 07:44:39 EDT 2016 | ariss_t
Very good explanation.. yep.. after 4 set of vision cable and a new usb3 port, the problem solve.. seems like the purple cable were the root cause .. The 1st cable on marginal pass failed but not shown the "camera 0" error and we still can poll the