Electronics Forum | Mon May 03 10:09:40 EDT 2010 | rmalick
get a TX1 error. Part remains in shuttle after getting a feeder mispick. machiune needs to br resert and we have to manually remove part from shuttle any idea how to eliminate this?
Electronics Forum | Thu Mar 14 18:16:58 EDT 2013 | isd_jwendell
With those interlocks tested, and confirmed good. I would check the end-of-travel safety switches next. It may think that the head is at the end of it's travel.
Electronics Forum | Fri Mar 03 10:45:10 EST 2000 | PAI
We are dealing with a unique machine that is having a couple of problems that we are trying to fix. A component code error appears whenever editing is done to any part of the program, array, or component library. This error we believe is causing t
Electronics Forum | Mon Jun 12 22:35:57 EDT 2000 | Suan
Is there any tablets to reducce Dross Produced by the chemical reaction of the solder pot.If there is ,please recommend and to what extent is the % reduction do we expected to see. thank you Panas
Electronics Forum | Fri Mar 03 10:45:10 EST 2000 | PAI
We are dealing with a unique machine that is having a couple of problems that we are trying to fix. A component code error appears whenever editing is done to any part of the program, array, or component library. This error we believe is causing t
Electronics Forum | Thu Jun 06 08:16:13 EDT 2002 | caldon
Jim- Sorry I can not offer advice on the Panasonic machine but do want to shed light on the Die and waffle pack issue. Take note that if the Die are loose in the pockets the balls or terminations could be damaged. The thin layer that the ball is atta
Electronics Forum | Mon Aug 25 22:14:34 EDT 2003 | davef
You need a nylon with a heat deflection temperature [heat distortion temperature] - 0.45MPa ( C ) similar to your reflow peak. The HDT of the nylon in your connector is probably ~200*C. For more, look here http://www.tycoelectronics.com/environment
Electronics Forum | Wed Sep 10 16:37:25 EDT 2003 | terrapinstation
It depends on what you mean by control. The host that you mention is PanaPro Software. PanaPro will upload and download programs to your machine, as well as optimize the cycle rate for the program (or groups of programs). This is a product sold by Pa
Electronics Forum | Wed Dec 31 08:40:28 EST 2003 | tommy
The 1block switch in front,rear & air down sensor are connected in series. Another suggestion is to initialise the setting.Make sure you have a copy of the initial data before doing it. Tell us what is your finding.Maybe you already have a solution.
Electronics Forum | Tue Jan 09 08:26:51 EST 2007 | stepheniii
If your boards are not totally rectangular part of the board can stick out past the stopper. If the fiducial is there then you can't use it. Also make sure you are not using panel fiducial co-ordinates and then expanding those out with panelization