Electronics Forum | Thu Oct 17 14:15:31 EDT 2019 | tey422
Try to check if there any foreign objects drop on the tool bank first. Even a tiny passive part could prevent the proper function of "open" and "close" of the tool bank. That's something to check too but always overlooked.
Electronics Forum | Thu Oct 17 14:47:17 EDT 2019 | mendezt6
Thanks cleaned it all out. I’m not sure how to check for proper “open” and “close” function. Or how to unlock tool manually.
Electronics Forum | Thu Oct 17 15:42:08 EDT 2019 | tey422
I haven't played with the Mydata machines since 2007. All I could remember is: There is TPSys that you need to log in to access the calibration/advanced settings. From there you should be able to find what you are looking for.
Electronics Forum | Fri Oct 18 16:21:27 EDT 2019 | tey422
Since you have a 2nd machine, and another A12 tool, that would be a lot easier to troubleshoot by using the swap part method. Also, try to compare the A12 parameter from the 2nd machine to the "trouble" too.
Electronics Forum | Fri Oct 18 16:26:54 EDT 2019 | mendezt6
Swap part method??? Are you meaning swap the tool banks? The tabs on the tool bank look good, but if it’s tweaked slightly that would be hard to tell. Sorry, I’m just an operator/programmer. The person that did all this stuff left suddenly.
Electronics Forum | Mon Oct 21 11:05:57 EDT 2019 | tey422
With the given update you provided, that would rule out the nozzle tool issue. If the parameter looks fine, then the issue would be somewhere around the nozzle tool bank. Need to check open and close release. If the nozzle seats flush "not tilted" w
Electronics Forum | Mon Oct 21 11:25:16 EDT 2019 | mendezt6
It sits flush in the bank and twist fine. The open and close are the 2 tabs on the tool bank right? When it’s closed the tool is twisted so it can’t pull up and open is the opposite?
Electronics Forum | Fri Dec 06 10:08:32 EST 2019 | davef
If all else fails ... Mycronic Ltd., Unit 2, Concept Park, Innovation Close, Poole, Dorset, BH12 4QT, Tel: +44 1202 723 585 Fax: +44 1202 723 269
Electronics Forum | Fri Dec 06 10:33:45 EST 2019 | paulanderson
Thanks Dave, I have already called and was told to fill in an online enquiry to the technical department and I am yet to get a reply :(
Electronics Forum | Fri Mar 11 09:23:44 EST 2022 | paddymanoj
Thank you very much for the reply. So I can use these magazines with any other MYDATA machine, right?
