Electronics Forum | Wed Jul 30 00:47:10 EDT 2014 | matusov
Hello gurus, I am a hardware designer with a small company. We are about to send a new PCB for fabrication. This board uses dozens of tiny QFN, DFN, and similar packages. As a final check I have been going through the datasheets of all these parts t
Electronics Forum | Mon Jun 21 12:57:10 EDT 1999 | Earl Moon
| | I dug through my big box of office crap and found the disk with my technical papers. I posted the one on process control in the SMTNet library. It covers a lot of ground on what causes defects in the wave (too much or too little of something),
Electronics Forum | Mon Jun 21 13:02:59 EDT 1999 | Earl Moon
| | | I dug through my big box of office crap and found the disk with my technical papers. I posted the one on process control in the SMTNet library. It covers a lot of ground on what causes defects in the wave (too much or too little of something)
Electronics Forum | Mon Feb 16 22:34:24 EST 2015 | anvil1021
WEll unfortunately I know the answer to your dilemma all too well and I will make it easy for you. The Koh Young takes a miracle to program and the Mirtec has a superior software and 3D system when you have the MV9 system. Just to day I was measuring
Electronics Forum | Mon Feb 16 12:33:58 EST 2015 | ianatvadatech
Hey Syed, I've been running the MV-9 for just over a year. We shopped around very extensively (two APEX shows) before switching from yestech to mirtec and we bought two of the best systems they had to cover the four lines we run. Two systems are fa