Electronics Forum | Sun May 24 14:10:42 EDT 2009 | grantp
Hi, It looks like your machines are so old, that anything built within the last 10 years would look like magic to you. Odd post, and does seem like an add for juki. Grant
Electronics Forum | Tue Nov 15 22:08:58 EST 2011 | nevercry14
Thats the odd part that i can zero set no problem just when i try to run idle the sz sensor ok when goes down but when it goes back up its not bieng retracted up so sensor stays off n eror acurs again any ideas.
Electronics Forum | Wed Oct 17 08:09:09 EDT 2012 | fujiphil
This problem is caused by poor pick-up. Check the pick-up from MTU to shuttle, then shuttle to placing head 1. If the pick-up is not centered, adjust proper data.
Electronics Forum | Wed Oct 17 14:26:30 EDT 2012 | dman97
With that said, do you happen to have the calibration procedure for the MTU? I already have the X0 Y0 jig. Just need to know where exactly I am supposed to calibrate with regards to the actual trays.
Electronics Forum | Fri Jun 05 05:54:07 EDT 2015 | JB
What we have found after using the machine for a while is that its difficult to set up most odd / uneven parts. The best way we have found is use the trimmer package and then use the rough check feature, that seems to work well with most things.
Electronics Forum | Tue Apr 15 14:19:19 EDT 2014 | horchak
This does not look difficult. It appears the rectangle of proper size and spacing would work for both, or even a square pad. Don't make it more difficult than it should be. But then I could be missing something?
Electronics Forum | Tue Apr 15 16:07:18 EDT 2014 | rway
Rather than using an over-lay of both pads, I would just stay with a rectangle pad shape, a little wider to accommodate both footprints. Keep it simple.
Electronics Forum | Thu Dec 15 12:45:15 EST 2016 | emeto
llllGodly, I did try before, but it wouldn't pick it - it will automatically select a tool for the single head. Do you think it has something to do with the fact that IO used ODD SHAPE recognition?
Electronics Forum | Wed Apr 05 12:27:52 EDT 2017 | emeto
the package should have nozzle(midas) and camera pre-selected(hydra camera will not work(try standard or high resolution). Odd shape recognition type will not use auto teach option(try chip, leaded, BGA.... )
Electronics Forum | Wed Aug 09 10:39:34 EDT 2017 | abruno1995
I am trying to get a picture from my manager because its very odd. Its not assembked they are bare boards