Electronics Forum | Mon Oct 08 17:58:07 EDT 2007 | actech
I have a CSM 84 that preforms origin and manual opperation. The Comp. and Brd. DATA is all present, However when I try to place in run mode the Lines of the program do not load and I get an Error. and when I press the reset The program lines do not l
Electronics Forum | Tue Oct 05 16:53:31 EDT 2010 | loyrickie
Never seen, or worked on one of these machines. After turning the unit on and hitting f5 to return to origination, I receive error message "37- Head LOWER POS. SENSOR OFF!". I also have no service manual, just replacement parts catalog and operatio
Electronics Forum | Fri Dec 31 12:26:29 EST 2010 | kvael
Has any one had this problem? Dynatech says it is the I/O Dpram board, sold me one that dosen't work. Bought a second Dpram from SMTBOX, still have the same original problem. During Dpram initialization error comes up "no command response from handl
Electronics Forum | Mon May 19 14:29:27 EDT 2014 | wendynguyen234
We have a Samsung CP20 with window 95, S-2000 MMI version 1.27 from Manncorp Inc. that freeze on window 95 screen. It was found that the mother board was at fault & need to be replaced. We replaced it with a compatible one & kept the original hard dr
Electronics Forum | Sat Sep 05 16:09:10 EDT 2015 | emanuel
Need assistance - I want to disconnect an unused LCS module from an Emerald machine. I disabled the tray changer and buffer conveyor in the machine's configuration but I still get an L212 error on the bottom of the screen and the machine hangs during
Electronics Forum | Wed Nov 14 19:33:20 EST 2018 | reckless
When trying to save a program onto a floppy disk I get this error on the screen. The file was being continuously saved on HD but when I tried saving on the floppy as a backup all data was lost and there was no way to recover original file. What k
Electronics Forum | Wed Jun 24 06:18:59 EDT 2020 | bukas
there is a oven setup wizard, I think you should be able to adjust probe offsets there. are the probes original? maybe they are replaced with inadequate ones? also, contacts on TDMs are weak, give them a good clean if you havent already. if you get "
Electronics Forum | Tue Dec 27 09:39:36 EST 2016 | westshoredesign
Thank you for the reply, MPMEng. I received the Speedline UPG-026/27, but it actually came with the incorrect mouse. Since original post I've contacted seller, received correct mouse, successfully installed drivers, encountered a new issue. At thi
Electronics Forum | Thu Jun 08 22:54:57 EDT 2017 | palsrvs
Hoping to get help on our Samsung CP40. We are trying figure out what part to replace for a Z height motor alarm detected Error Code 1523. Originally Head 1 was having this error. Swapped out I/O board and Z-Axis control for head one and same error s
Electronics Forum | Sat Sep 05 02:34:19 EDT 2009 | martinphill
check R-axis mechanical backlash... After checking R Axis Backlash, Coupling. If still the Problem continues. We have the same issues & when we asked Jagadeesh Rajagopalan , he suggested following action item Check the servo Error display. If it i