Electronics Forum | Wed Jul 13 16:44:12 EDT 2005 | dk
Hello all. I need a file or a link to a kind of library for package, component picture and description. I need it for programming AOI templates. Thanks. Good day
Electronics Forum | Fri Feb 16 09:40:19 EST 2007 | kmeline
I am looking for recommendations for working with this package. We have ran some QFN20's but this one is a little smaller and lead-free. If anyone has experience with this, I welcome your comments. Thanks
Electronics Forum | Mon Feb 19 08:56:08 EST 2007 | azbvc
Mark, Did you check with manufacturer datasheet?
Electronics Forum | Fri Feb 25 11:13:32 EST 2000 | Russ
This probably won't help much but I find it at least a little interesting. During some experimentation recently I accidently loaded a board into the wave upside down and it had a PLCC 68 package along with other types of components that had only bee
Electronics Forum | Fri Aug 04 04:26:31 EDT 2000 | Charles stringer
I am experiencing a problem when soldering down a TO263 package. The device has a large solderable tab (approx 8mm square)on the back and 5 leads. Sometimes the leads are not soldered to the board properly. I am using a metal mask with 9 "windows" of
Electronics Forum | Fri Feb 25 11:13:32 EST 2000 | Russ
This probably won't help much but I find it at least a little interesting. During some experimentation recently I accidently loaded a board into the wave upside down and it had a PLCC 68 package along with other types of components that had only bee
Electronics Forum | Fri Feb 25 16:10:11 EST 2000 | Dave F
Russ: You're correct, running second side SMDs on the wave without adhesives is more fun than a lot of people think. Ta. Dave F
Electronics Forum | Fri Feb 25 16:10:11 EST 2000 | Dave F
Russ: You're correct, running second side SMDs on the wave without adhesives is more fun than a lot of people think. Ta. Dave F
Electronics Forum | Tue Feb 20 09:46:17 EST 2007 | kmeline
Thanks for the info. I will inform the QA department about the lack of a toe fillet. I am sure it will be an issue.
Electronics Forum | Tue Jul 13 11:21:28 EDT 2021 | stephendo
You may have to use an adaptor board. A small board with one footprint on one side and the other on the other side. Do not assume that the pin outs of the two parts are the same. I have seen smaller parts with a different pin out than the bigger part
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411