Electronics Forum | Thu Apr 07 09:24:47 EDT 2011 | rway
What version of sw are you running? There are some new features in 2.7.7 and earlier that may be of benefit to you. With chip caps you are testing for presense/absense. The gain/offset feature can be used to give you better contrast between the pa
Electronics Forum | Mon Nov 09 09:44:22 EST 2015 | davef
Purpose. This describes setting-up a wave soldering system set-up for a new assembly design or checking a wave solder machine operation with a test board. Applicability. To be used for new design printed circuit assembles and during machine accept
Electronics Forum | Wed Feb 09 11:37:26 EST 2005 | pjc
Technical support cannot help with this issue, especially Electrovert tech support, those guys only know soldering and cleaning machines. Contact Jim Kaler at Camalot Applications Support: 603-641-8666 ex7208 or jkaler@speedlinetech.com Tech support
Electronics Forum | Fri Dec 17 18:21:43 EST 1999 | Clarissa L. Ortner
We are a small start up. We will be buying a stenciling machine and semi automated pick and place. ( We have the oven) We are presently stenciling without any assit and loading leadless parts only(no fine pitch) by hand. We need to improve thrupu
Electronics Forum | Tue Aug 11 12:28:51 EDT 2009 | JWPlainview
What are some overlapping characteristics between ITAR and AS9100 for PCB fabrication?
Electronics Forum | Tue Aug 05 21:08:10 EDT 2014 | isd_jwendell
You are correct about the Manncorp machine, it was an MDC machine. The Essemtec machine is old(ish) but still runs fine, and last I knew they were still supporting it. My recent problem with Essemtec was in regards to software. I found a bug and sim
Electronics Forum | Thu Sep 05 23:18:03 EDT 2013 | feiyangniao
There is a new toy I received today: a NeoDen TM-240A automatic desktop pick and place machine! I’ve kept my eyes on this baby for a quite a while, and finally decided to make a purchase last week. The shipping was very fast: DHL from China, a total
Electronics Forum | Sun Aug 03 09:44:10 EDT 2014 | isd_jwendell
I have 2 experiences with Manncorp machines and support, both were not good. Example: One manual was written in Japanese. I requested an English version, but was told it doesn't exist so too bad. I had to pay a local translator to get what Manncorp
Electronics Forum | Tue Jun 25 01:24:25 EDT 2019 | sssamw
That is possibley CTE mismatch between QFN and PCB material, the thicker PCB the higher fail rate.
Electronics Forum | Mon Jan 25 01:35:56 EST 2010 | orproadamshaw
Hi, As stated above development of the systems we took over from Orbotech has not ceased. I don't know which geographic region you are in, but your first contact should be either a Business Partner, or ORPRO Vision support direct in the region. On
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830