Electronics Forum | Fri Jul 24 02:57:05 EDT 2009 | fede
I use Center Edge, and adjust stencil offset. It's very easy, you just have to give it the PCBs width. An other advantage is that If your PCB has scrap strips, and you lose them, or PCB changes, you can print it anyway.
Electronics Forum | Mon Jan 10 23:05:32 EST 2011 | aungthura
Hi Eadthem Your way isn't work for our big size Board(620x440x7mm).After pressing the Alu Bars on the edges, the warpage happened more wider.So, we r using clamps to adjust PCB expension. Anyway, thx for sharing.
Electronics Forum | Thu Apr 14 14:16:22 EDT 2016 | joelperez
Has anyone use both methods of depaneling on PCB breaktabs? meaning v-score at the edge of the pcb and mouse bites on the opposite side of the tab (break out panel)? Thanks
Electronics Forum | Wed Feb 28 03:57:46 EST 2001 | peterbarton
Are you using a water based flux? Are the solder balls mainly around or near non-plated holes or near the edges of the PCB? If so the preheat must be set so the water content of the flux is fully evaporated before the board hits the solder wave. If
Electronics Forum | Mon Sep 24 07:38:01 EDT 2007 | chrispy1963
I never saw in any post if your machine uses the camera to find the board edge or if your machine uses the bottom front rail mounted board stop sensor. Also is this with only one particular job you run on this machine or is this happening with ALL
Electronics Forum | Mon Jun 19 21:37:14 EDT 2000 | Dave F
Mike: Look a the Hadco DFM manual ( http://www.hadco.com/ ) Yano if you�re lookin� for uniformly smooth (not silky smooth) board edges, have you considered scoring to separate your boards? Scoring has: * Minuses (straight lines only, stress on so
Electronics Forum | Fri Nov 27 08:58:39 EST 1998 | Des
I have a PCMCIA type pcb with an 0603 resistor situated exactly half way along the longest edge the device is 2mm form the edge of the pcb. I have experienced incidences of the device fracturing after breakout (hand operation) (pcbs are routed) Coul
Electronics Forum | Tue Dec 01 10:19:43 EST 1998 | Dave F
| I have a PCMCIA type pcb with an 0603 resistor situated exactly half way along the longest edge the device is 2mm form the edge of the pcb. I have experienced incidences of the device fracturing after breakout (hand operation) (pcbs are routed) Co
Electronics Forum | Tue Feb 28 16:58:39 EST 2006 | PWH
Too fast heating/cooling rate in reflow (look at mfg's spec.). Z "overdrive" on pick and place or chipshooter though unlikely I would say. Depanelization method (bending a scored board to break it is tough on things). Bad PCB design - cap. too clo
Electronics Forum | Thu Nov 13 11:45:04 EST 2008 | pbarton
We have seen a similar problem. Turned out to be mechanical stress on the component caused by the method of location and clamping at ICT. Where is the component located on the assembly? Poorly adjusted clamping pillars on clamshell fixtures can cause
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830