Electronics Forum | Wed Aug 05 07:38:17 EDT 2020 | bangir
Hi Cris, Yes, The PCB thickness is 1mm. the PCB position below the rail thickness when the table go up the print position. Please advice or do you the service manual book.
Electronics Forum | Tue Aug 04 13:45:03 EDT 2020 | oxygensmd
There are one value for thickness during PCB-teach function which is the PCB thickness. The other one is the camera focus in machine option but it is a dangerous function because the camera focus is adjusted by raising/lowering table.
Electronics Forum | Thu Sep 02 23:59:35 EDT 2021 | mokshamanthra
Hi, We have a PCB with layers defined for a thickness of 1.6mm from a customer . Is it possible to make it 2mm without affecting any Cu traces or layers , just by altering the FR4 material only.
Electronics Forum | Tue May 28 22:56:01 EDT 2019 | dhanish
When do we need to implement a pallet for a PCB during SMT process?Any recommendation on PCB thickness,panelized PCB,width and length etc?
Electronics Forum | Mon Jun 03 13:26:32 EDT 2019 | az2019
Hi, I have a general question about the relationship of PCB thickness and BLR testing result. For example, I have QFN6x6 parts mounted on board in 1.2mm, 1.6mm, and 2.4mm thickness. All boards have 6 layers of Cu. Studies show thicker board gives les
Electronics Forum | Wed Jul 24 09:54:49 EDT 2019 | amitthepcbguy
Typically, the reliability of PCBs suffers significantly due to the increase in aspect ratio. It is not preferred to opt for high thickness boards. However, I would like to point out that your assumption seems to be wrong as board layers do not direc
Electronics Forum | Tue Sep 07 21:15:20 EDT 2021 | dwl
This should be possible, but definitely get the OK from your customer first! Layer thickness may effect things like impedance, EMC, or other electrical properties of the assembly. out of curiosity, why do you want thicker boards?
Electronics Forum | Thu Oct 07 12:42:13 EDT 2021 | ervin
Hi I addition to the mentioned electrical effects, there are also reliabilty issues with increasing the board thickness, such as increased aspect ratio for the vias or registration difficulty
Electronics Forum | Tue Aug 30 22:38:54 EDT 2005 | cabs
Does any one knows where to get a plating thickness meter that can be use in the fine pitch contacts and trace in PCB application like BGA pads? If there's a hand held device at lower cost much better... Also if you can recommend companies that offer
Electronics Forum | Sun May 24 21:12:59 EDT 2009 | keith78
I have a problem recently to qualify QFN package on solder joint reliability. The pcb thickness stated in IPC-9701 is 2.35mm but from the in-house test, QFN surface mount on 2.35mm thickness PCB board have a short cycle to failure due to higher CTE m
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830