Electronics Forum | Wed May 08 09:39:14 EDT 2013 | dyoungquist
Your centering jaws are likely okay. It's the 25V that runs the centering jaws that is having the problem. Could be the circuit that produces the 25V is having problems after warmup or maybe the motor that runs the centering jaws is going bad. Loo
Electronics Forum | Mon Mar 16 14:13:15 EDT 2015 | swiese242
We have a CP-743 and recently purchased another one. I would like suggestions on tapes. The only thing that slows the machine down is tapes on reels getting stuck and/or jammed. Does anyone have suggestions for this problems or how do you keep this t
Electronics Forum | Wed Jul 08 10:29:14 EDT 2015 | goodting
Dear SMT Specialists Had anyone encountered GSM ADvantis zeroing failure problem? The x-axis is idle while the y-axis is waiting to be activated. My initial guess is either Axis control board or machine configuration conflicts. How to fix it? any le
Electronics Forum | Mon Sep 09 11:36:17 EDT 2013 | moussa
We have an unloader jot Automation : - NO:35036A-7.1 - code:J213-25.5/5 - SNO:10201646 0.4) The problem is that the PT control give an error message witch is : “No direct information is set! use the support tool to set the PT control area and PT
Electronics Forum | Mon Sep 21 07:47:31 EDT 2015 | koprivecj
Greetings! I have a problem with PAD connection in inner layers of 4 layer PCB (signal1, GND, POWER, signal2). Sometimes there is no connection between pad and power plane. I'm using termal relief around PAD in inner layers (same shape pad trough who
Electronics Forum | Fri Mar 08 12:22:18 EST 2002 | pr
Have you contacted Fuji? I believe we had the same situation a while back and (I think) it was a proper setting and not a sensor problem. A tech. can probably walk you through it over the phone. good luck, pr
Electronics Forum | Fri Mar 08 22:07:31 EST 2002 | winter
I think the reason of the problem is the sensitivity of some sensor.maybe it's the main conveyor arrival sensor .I think you can do a test , make the sensor always on, and tese.
Electronics Forum | Tue May 11 10:43:37 EDT 2004 | Melissa
Has anyone experienced problems lately with excess flux residue left on the board after reflow when using Alpha UP78 OSP paste? We are getting a component failure that the designers are blaming on too much residue. Thanks