Electronics Forum | Wed Jul 06 09:10:55 EDT 2011 | bobpan
i have seen bad motor cables cause the problem......you can ohm them out to the driver cards or if you have extras....replace them Bob
Electronics Forum | Sun Dec 04 15:42:21 EST 2011 | ngineer
Thanks for the reply bobpan. I had the motor power on. I did have a side panel that was not shut all the way. Once I shut that, the error went away and it made it through its startup sequence. No errors. Thanks for the help.
Electronics Forum | Fri Feb 24 13:21:42 EST 2012 | bobpan
The correct sequence steps should be: 1. tep hold 2-? pick/place/nozzles tep vpass goto 1 This is out of the programming manual.
Electronics Forum | Tue Feb 28 12:23:36 EST 2012 | veeckm
It sounds to me like your using only the Global fiducial mode. If your running multiple images on one panel use image fiducials instead
Electronics Forum | Mon Jan 21 10:21:12 EST 2013 | bobpan
Glad you got it working...if I had worked on them in the last 15 years i might of remembered some of the questions you were asking me a little better. But...hey....its working....thats all that counts.
Electronics Forum | Tue Sep 25 13:33:02 EDT 2012 | bobpan
I dont think you are going to find schematics for that board. Looking through my old stuff....i dont have it and i dont recall it being in the schematics. Maybe someone else can get you a set of schematics though. Good Luck
Electronics Forum | Thu Feb 14 08:58:31 EST 2013 | bobpan
I would call PPM and ask them. They are still selling the machines. I dont think a vga monitor will work but a monitor with a bnc connection may work.
Electronics Forum | Thu Feb 14 09:13:28 EST 2013 | leemeyer
You will need to purchase a VGA kit for your MVS100 board. Call PPM if they don't have one let me know I have a spare kit That I would consider selling.
Electronics Forum | Mon Apr 01 14:35:52 EDT 2013 | microaide
AutoProgram has no password. I did a fresh install of AutoProgram from the original factory floppy disks. There are no passwords, nor any way of assigning passwords. Have you ever used AutoProgram?
Electronics Forum | Mon Apr 01 15:45:05 EDT 2013 | leemeyer
In order to create a new part you must first select one of the parts that is installed with autoprogram. The edit button will become active so that you can create a part.
