Electronics Forum | Fri Mar 11 14:04:34 EST 2005 | Micheal
I changed both cables and still the same thing. I have not changed the quad align cable yet. Any other ideas. Also when I do a run pickup 1 it works normal but when I am in run mode forget it, the z-rod now dont even go all the way down.
Electronics Forum | Mon Mar 14 08:35:27 EST 2005 | ???
no...its losing its position and it homes ok so the sensor is not the problem.....there is a mod code that sets the illumination level for the quad align....make sure that is at 200 or higher. You may want to change the qa card if you have another on
Electronics Forum | Wed Jan 13 22:59:53 EST 2010 | goolash
The Central Controller software on our Quad IVc machine is refusing to allow me to add local fiducials. Essentially, I follow the manual's directions, and when I press 'N' for New, it asks me to enter the placement number. No matter what number I e
Electronics Forum | Mon Mar 22 10:33:11 EDT 2010 | bobpan
I dont recall autoprogram having a password. If its central controller you need to get into....try QUAD (in caps). There is a way to delete the password file but its hidden in the root directory (for central controller). The file is called QSPASSWD.S
Electronics Forum | Wed Feb 08 16:01:56 EST 2012 | gosswald
Are you using Auto Program to generate the board program? If your camera offset and mod codes are OK I would check your board position settings in Auto Program and make sure they are correct. For me at least, board globals, position, and fidicuals
Electronics Forum | Tue Sep 25 05:58:16 EDT 2012 | bobpan
I believe the Led's should flash 3 times when the card is booting up/ powering up normally. There was no board troubleshooting back in the day and we just replaced the card. Make sure the metal cover is grounded to the machine.....this sometimes caus
Electronics Forum | Mon May 16 19:57:51 EDT 2016 | rx8pilot
I recently purchased some used ThinPRO precision feeders for my Quad IV-C (PPM 4000C). They are in great shape, but I do not know how to program them to index at 2mm Does anyone have experience with these that know how to program them? I can only go
Electronics Forum | Thu Nov 12 04:40:03 EST 1998 | Galen
| Scott - Good to see things are going well for you. With regard to your comments, Quad has introduced a complete line of Semi-conductor/APT machines (Q Series) that support both SMT and Semi-conductor applications. The machines were introduced in
Electronics Forum | Wed Feb 27 12:38:49 EST 2002 | stmerkt
Tyco has recently completed development work on the ThinPRO feeder. This feeder provides exceptional performance for 0201 and 0402 applications. The feeder is compatable with the IV-C, QSV, QSX, QSP-2, and APS platforms.
Electronics Forum | Fri Mar 11 09:32:03 EST 2005 | ???
change the x/y ribbon cable's.....you will probably find one of those are going bad. good luck
