Electronics Forum | Sat Jan 20 18:54:47 EST 2007 | al
First I would check the cable,swap it with another fuji machine! Or have you tried to "reset start".risky if you have no comms but you need to get to the bottom of the problem...
Electronics Forum | Mon Mar 05 18:20:18 EST 2007 | paul_stamper
De-Humidification cabinets. The draw back with Nitrogen is that it does not reset clock life. The De-Humidification cabinets will remove moisture and has been added for some levels in the standard.
Electronics Forum | Thu May 01 07:33:19 EDT 2008 | realchunks
Jim, You need to repair or by-pass the cover interlock. The machine thinks it's open and will not procede any further. They all do it, even the new models. Once you get past this warning - you will get the the RESET window - garanteed.
Electronics Forum | Thu May 08 08:06:08 EDT 2008 | tazzntigger
The iron of my choice would be the Hakko iron. They have a double plating on their tips. The cost is relatively low and have a digital read out. They can also be locked out so that the temperatures can't be reset by the operators. This is the onl
Electronics Forum | Mon Sep 22 07:30:59 EDT 2008 | jdengler
When our IP-II did strange things we would do a reset start. This fixed a lot of odd behavior. Jerry
Electronics Forum | Mon Nov 24 12:48:14 EST 2008 | dman97
Does any one know if there is a master password for these machines? My company recently acquired one of these printers, but the previous company who owned it had password protected the edit data and maintenence functions. Does any one know how to r
Electronics Forum | Wed Aug 26 07:01:42 EDT 2009 | mysmt
Hello, Facing a problem intermittently . ERSA EWS 330 wave solder machine is restarting in continuous reset & restart mode. Next day machine works normal.
Electronics Forum | Fri Oct 02 12:57:13 EDT 2009 | dnebel
Looks like you'll need to reset the controller. That will require turning the Run/Halt swith to Halt and back to Run. That should put an @ prompt on the screen. There is a list of inputs you continue through to reinitiate, but I have forgotten the
Electronics Forum | Sat Mar 20 22:47:10 EDT 2010 | claudea2
I have recently purchased a used Quad 4C. I do not have the password for the AutoProgram. Is there a way to reset the password? Thanks Claude Arpin
Electronics Forum | Thu Jun 10 07:44:41 EDT 2010 | jdengler
Did the machine work when you first installed it? Have you done a reset start yet? Make sure you have air applied when you power up. The IP's don't like to power up without the air.