Electronics Forum | Mon May 02 23:42:44 EDT 2016 | ttheis
I have a strange issue where all 4 spindles of head 1 on my GSM1 are able to place small parts without a problem until the very end of the routine where a large electrolytic aluminum capacitor is placed. The part is successfully picked out of the fee
Electronics Forum | Tue May 03 10:58:56 EDT 2016 | ttheis
I'm not sure- I'll check that. The machine is running ups version 3.2.2c. Previously I just went into the order list and selected to move the component in the list, put it at the end before the repair step and added an end block step after the compon
Electronics Forum | Thu Jun 04 09:40:38 EDT 2020 | kasia
Hi everyone, Im currently working on little bit old SMT machines (Europlacer) and I have problem with nozzles , everytime when I want to run a program I got information "26 nozzle not picked or error of detection". I restarted machine, checked the
Electronics Forum | Wed Feb 03 20:26:49 EST 2010 | mika
Hi, First: 1. What os/system? 2. what s/w version? 3. what type of machine model? 4. What type of head configuration? 5. Do you have this head front or back? 6. Do you have encounter this problem before? 7. Have you recently placed any new "high com
Electronics Forum | Mon Jan 13 08:35:51 EST 2020 | griinder
The holes are calibrated in MSetup. Generally, I have never had luck using the auto teach for the nozzle changer. We would teach them each manually. Before doing this, you need to narrow your issue down a bit more. Which head gives you this error?
Electronics Forum | Wed May 11 17:25:22 EDT 2022 | SMTA-64387687
You've replaced the sensors and cleaned any grease residue inside the Midas head, and you're still getting this error. You can check the connector on the little board, on top of the Midas, where the flex cable plugs in. I don't remember, off the t
Electronics Forum | Thu Feb 04 02:46:39 EST 2010 | dilogic
OK, here we are: 1. OS is OS&2 2. Sw. is USOS V1.14 3. GSM1 4. 2 Flex2 heads 5. Problem is on the front head 6. No 7. No 8. It just stops in the middle of the placement phase, with the head over PCB area. Usually 2 parts are still held on the nozz
Electronics Forum | Mon Apr 27 11:29:06 EDT 2015 | chris_jayconsystems_com
When I do the adjust to make sure the vision and tolerance is working it works perfectly. But if the machine runs a board I am riddled with this. I have checked the vacuum levels on all the heads and they are within where they are supposed to be for
Electronics Forum | Mon Jul 25 17:27:45 EDT 2016 | victoriajon
Up and running smoothly this morning, but got the attached error when switching from a reel feeder to a tray of the same part. We are getting this error message during setup - any suggestions are welcome. I am available to answer any questions that
Electronics Forum | Thu Feb 14 17:36:28 EST 2013 | dontfeedphils
I'm trying to get an '07 Accuflex into production and I seem to have a small problem. When trying to calibrate the zero pressure point on the squeegees I drive them down until they are touching the stencil and once they touch the stencil they run ou