593 scott results

Electronics Forum: scott (Page 8 of 60)

Re: footprint max505

Electronics Forum | Wed Mar 11 08:43:37 EST 1998 | Scott Cook

| I'm designing in a MAX505 but i can't find the footprint for this device Try visiting: http://www.mxim.com/ and request a data sheet on the Max 505..... Scott Cook Scottc@t-com.com

Re: hack

Electronics Forum | Thu Jan 08 21:37:33 EST 1998 | Scott Cook

| If anyone has any type of info on how to hack into websites and/or get there password access please email me. Bumbling boy, Stay off of this site, idiot. This is for serious professionals, not kids who are screwing around with nothing but time on t

Second Pass In Wavesolder

Electronics Forum | Thu Jan 03 07:38:01 EST 2002 | davef

Scott is correct. Expanding a bit, the SMTnet Library has a "Terms & Definitions" listing in the "Standards & Terms" section.

Second Pass In Wavesolder

Electronics Forum | Thu Jan 03 07:49:20 EST 2002 | hany_khoga

Thanks Scott: The Assembley is Mixid ( reflow then wavesoldered). It is One curcuit. Is the Tg averagely known for FR4 PCB assemblies? Hany

pc board defects

Electronics Forum | Sat Sep 14 20:42:48 EDT 2002 | kenbliss

Hi Scott Thanks for your comments, you stated "The highest attributer was clogging apertures in fine pitch, resistor networks, and BGA, Micro BGA areas" was this do just to the size of the aperture or bad or old paste or debris from inadequate clean

Solder Paste and fine pitch components

Electronics Forum | Wed Sep 18 20:55:33 EDT 2002 | scottefiske

I'm with you dave...please provide specifics as to defect condition... Are you getting good wetting to both land and lead? Is there any repeatability to lead/location/device? Do you have paste inspection capabilites to verify deposition? Is it a Pala