Electronics Forum | Thu Aug 05 12:28:44 EDT 2004 | jasont
Hi YuKim, Have you considered purchasing 2nd hand machines? Tekmart International Inc. can help you find a cost effective solution for your additional SMT line requirements. We have in stock and access to several of the machines you've listed; -
Electronics Forum | Wed Jan 12 12:06:55 EST 2005 | Grant
Hi, The MYDATA is a very flexible machine, however it's slow as a chip shooter, and really needs Myspeed to work to get as much speed as possible. It's also wasteful to get chip placement speed because you need to repeat feeders of the same componen
Electronics Forum | Thu Jun 23 20:09:03 EDT 2005 | Stefan
Optimizers for pick and place machines are very specific for the type and model of the machine you are using. A chip-shooter will run at optimal speed with the same type of nozzle and minimal table movement. Most X-Y tables have a faster X-axis than
Electronics Forum | Sun Apr 09 14:20:17 EDT 2006 | greatexpectations
Hi, This setup was recommended. Target is 20,000 board output per day FUJI GL-541 Glue Dispenser (USED) 32K FUJI GL 641 SCREEN PRINTER (USED) 57K CP-643E CHIP SHOOTER 255K (150 FEEDERS) FUJI QP-242E IP3 110K REFLOW 8 ZONE (IS THIS ANY GOOD) 4
Electronics Forum | Fri Mar 10 05:16:32 EST 2000 | Jeff
We have nozzles breakage troubleshooting since we uses the PANASONIC RMA nozzle on our MV2x Chip-shooter. Our nozzles are breaked in its opening, and cause components damages. Also, if anyone with experience in nozzles breakage with PANASONIC RMA No
Electronics Forum | Tue Oct 03 13:14:37 EDT 2000 | jarnopy
Hi, You are right, but if you don't have very fast ship shooter then i think that dispenser is better. I have experience on both variation. If you have a line dispenser then speed is quite good. Most often it is sufficient. And unfortunate often qual
Electronics Forum | Fri Mar 10 05:16:32 EST 2000 | Jeff
We have nozzles breakage troubleshooting since we uses the PANASONIC RMA nozzle on our MV2x Chip-shooter. Our nozzles are breaked in its opening, and cause components damages. Also, if anyone with experience in nozzles breakage with PANASONIC RMA No
Electronics Forum | Fri Jul 23 10:33:14 EDT 1999 | Mark D. Milward
Has anyone had the experience of losing components after they have been placed by the HSP 4796 because of table movement. I've worked on the 4760s, 4780s, and 4785. I don't know if this is a problem or not. We are trying to determine if this a possib
Electronics Forum | Thu Dec 17 19:44:04 EST 1998 | Dave Kalen
| What is the CPH for Universal/Sanyo chip shooter? Spec. needed only. Thanks | Mike, just like the rates that Dave F said, the tact times of the newer Sanyo/UIC machines is .1 or 36000cph. Because of the Direct Drive head, we have little derate so
Electronics Forum | Tue Oct 27 12:22:34 EST 1998 | Sanjay Bhatikar
Sirs, what would be a good way to judge the reliability/robustness of a stencil printer or chip shooter? Does any equipment supplier specify detailed maintenance schedules? Is there a source of machine failure data (MTBF, etc.)? I not