Electronics Forum | Tue Feb 22 22:39:22 EST 2022 | cirsol
Hi, Sorry I didn't see your previous post. I do have an update but will answer your questions first. {So you only rebuilt the MC HDD and didn't rebuild the Station PC? Am I right ?} Yes that's correct, we only rebuilt the MC HDD but were not able t
Electronics Forum | Mon Feb 01 04:57:08 EST 2016 | oxygensmd
If you can use the standalone mode then choose the program on "option" and somewhere you can load program - "aktuell". The "aktuell" program is the last program what was downloaded on this machine. In SiTest you can test and calibrate the machine. Y
Electronics Forum | Wed Aug 28 20:01:17 EDT 2013 | vinodkumar
can anyone help me how to get Siemens Line computer installation floppies or someone mail me the contents of the floppies of 00345544-01,00345542-01. I assume it is boot disk of 3-4 numbers. Request you to mail it to me or load it to a site and give
Electronics Forum | Sun Jan 03 04:26:36 EST 2016 | sarkhosh
Hi Dear sir I have a question,My F5HM machine have mc hdd problem and dosen't boot. would you please let me know where can I download or find the mc installer floppy. with regards Masih Email: sarkhoshm@gmail.com
Electronics Forum | Fri Nov 20 10:44:46 EST 2015 | cgreiner
Hello > > I got a SiPlace 80-S20 machine which had > a damaged hard drive in MC. I changed HDD and > re-installed RMOS + MC from floppies. Then I > turned on the machine (without any Line > Computer). > > The software on Station computer > wou
Electronics Forum | Thu Nov 13 06:00:24 EST 2003 | stefwitt
The Siplace web-site will not help you very much, because the HS 180 does not belong to the Siplace line. All the older Siemens machines operate with HP Basic and the computer hardware can't even be replaced with DOS based PC's. Dependent what type
Electronics Forum | Tue Jan 26 12:15:45 EST 2016 | mjscottinnc
We recently purchased a used HS50 and we are trying to get it up and running. We are completely new to SiPlace and I have a few questions about terminology. Machine Computer, Station Computer, and Line Computer. There appear to be two computers in th
Electronics Forum | Sat Nov 21 07:57:48 EST 2015 | micropak
Actually I from the SC I am able to ping both the MC and the LC. By switching the monitor display the MC shows text the last line of which says"Config completed enabling task". The ICOS display is a red cross hair. All the axis cards show green LEDS.
Electronics Forum | Mon Feb 19 20:43:57 EST 2024 | erici
Thanks again for the reply. I did what you mentioned on your previous message. When i rebooted the machine i came up with a "software booting" message and didn't go past that. I checked the MC and i got the error "no SRBS, system halted". What is S